would you pass this up also will it fit

I have chance to buy a 90% complete race car it’s a 95 cobra clone w/ 8000 original miles on the body really good paint , tell me if this deal is to good to pass up also will a complete 306 with long tubs out of an 88 fox fit?

For the go fast stuff, here it goes
Wheels and Tires
15x3.5 Weld Pro-Star up front Used, but nice
15x10 Weld Pro-Star out back with BRAND NEW MT ET Street 26x10.5x15
Front Suspension
D&D Drag K member ,D&D Caster Camber plates ,D&D A Arms ,D&D drag CoilOvers
Lakewood 90/10 struts ,Flaming River Manual Rack Kit, with billet shaft ,3" wheel studs ,Power Slot Rotors ,Stainless Brake lines ,New Pads ,New Calipers ,New Moog Ball Joints
Rear Suspension,
D&D Anti-Roll bar, D&D Rear Coil Over conversion, Lakewood rear 50/50 shocks
Axle tubes and Torque boxes welded, Double Adjustable Uppers
Lakewood Lowers
Rear End (Used about 2,000 miles)
31 Spline Axles ,Eaton 31 spline Diff ,3.73 Ford Racing Gears, Mac rear-end support
3" Wheel studs
Fuel System (Used about 2000 miles)
Sumped tank -10 feed, Areomotive/Paxton Fuel Pump, Paxton Fuel Filter -10 ,
-6 Return line, BG Y Block, SX Regulator
Other stuff
4130 8 point roll cage done by E&J auto works of Miami.
Flaming River Battery Turn off
Have all recipts, everything is BRAND NEW.

It also has a brand new PA C4 trans & converter ,trans brake

And a Holley commander 950 with a custom mustang harness

For every thing 7k

i cant post the pic's but its yellow and has no miles put on it since it was put together

GOT A PIC TO LOAD

what are you looking at? there is no engine in the car

i have all the prices he paid just in parts alone it comes to over 13K for just the parts thats not including labor or the cost of the car or to install all the parts and set up the fule system all the lines are run, The car has never run like it is all the part are new