Here goes...I was getting ready to install my new mechanical oil pressure gauge and started by taking off the stock sender so I could get all my fittings matched up...Well my buddy was looking for an accessory wire and somehow started the damn car and oil began spewing out of where the stock sender was...As soon as I realized what happened I immediatly ran over and shut the car off but not before it spewed almost all the oil if not all of it out...It was only running for at most 30 seconds...I hooked everything up put 3 quarts of fresh mobile 1 syn. in it and no noises, ticking or knocking and the dipstick says its full now so Im hoping I dodged a bullet here and didn't screw up my motor...Its a fresh motor with less than 10K on it...I should be good right???