crush sleeve

1991vert

10 Year Member
Feb 27, 2004
1,103
7
69
Ludlow, MA
last season i put in new axles and a differential and took everything out of the 8.8 housing. i dont think i tightened the crush sleeve enough and was wondering if i needed a whole new crush sleeve or could i just tighten this one some more?

i know you can never loosen them once you tighten them, but what about tightening more?
 
you need to go by turning torque my friend. you need a special turning torque wrench and you are supposed to measure it with the axles out of it. why do you think you didnt tighten it enough?

i know i need a beam style torque wrench which measure in in/lbs, but no one around here carries one. and ya i dont think i tightened it enough. i pulled out the rear end to weld the torque boxes and it was all gross up there - yes, it wasnt there before.
 
For Gods sake don't use an impact gun.I've done this for 25 years and not as a hobby.150 pds. ft. Correct way is a beam torque wrench with carrier removed should have 20 inch pds new bearings and 15 inch pds used bearings.
 
For Gods sake don't use an impact gun.I've done this for 25 years and not as a hobby.150 pds. ft. Correct way is a beam torque wrench with carrier removed should have 20 inch pds new bearings and 15 inch pds used bearings.

i know it's 10-15 in/lbs with a dial torque wrench, but i dont want to spend $150-$200 on something im going to use once. :( i wish autozone rented these things, but they'd probably get messed up faster than lindsay lohan at a party
 
well i bought one and just for giggles checked what the current preload was and it didnt even register on the torque wrench. i pulled everything apart and replaced the pinion seal just in case and put a new crush sleeve in and now it should be fine. now im just waiting on my rear end girdle to put it back together :D