Correct Cylinder Heads.

1BADLXCOUPE

New Member
Sep 24, 2005
23
0
1
florida
Im wondering what heads I can run with Dome Pistons, on my New Buildup.

*306 (Built by Panhandle performance)
All Forged, Steel Crank. Dome Pistons. (10.25CR with 64cc Cylinder head)
*Crane .530/.540 Camshaft.
*Edlebrock Performer RPM Dual Plane.
*750 Holley, Vac. Sec.

Im looking at Brodix's Street Design. Has anyone ever ran them?
Brodix ST 5.0
 
What part number pistons?
What's your deck height?
What's your piston to deck height?
What gasket thickness with 64cc cylinder heads make 10.25 cr?
Then call the cylinder head manufacturer. With your specs and theirs... someone should have a clue where you need to be.
I know what cylinder head I would use... but I'm not you.

As far as "...cant do better on a 5.0 than an AFR... IMO"... that's plain silly.
AFR 185s might be a nice match for that camshaft, but if you decide to make some horsepower later... they will not support big numbers.
 
How do you get that they wont support big horsepower numbers?

Any given engine's displacement and rpm will move the maximum amount of air as the valvetrain and intake system will allow in a N/A application.
Larger cylinder head runners, minimum cross section, valve diameter will make more power than the smaller.
Using the OP's combination... with the correct camshaft and AFR 205s, this combo will make more power and accelerate quicker than when the AFR 185s are installed with a matched camshaft.

I also know better than to say AFRs are the "best" cylinder head for the sbf 5.0.