Search results

  1. 9

    How do can I check the ignition system?

    How can I check the ignition system? I'm having a problem with my ignition system which I can't figure out. I know It's not my starter because i've replaced it 3 times, also I've replaced all the wires including grounds going to the battery, starter, alternator, and fuse box and terminals and...
  2. 9

    Anyone else have this electrical problem?

    I've noticed for the past few months my gauges will randomly flutter and just randomly move around (Temp, Oil pressure, electrical gauge, and tach). It also causes a drain on my battery when my car is off and i'll have to push start my car to get it running (jumping doesn't do it for some...
  3. 9

    Starting problems, any ideas?

    Recently my starter went out so I replaced it and the car started fine for about a week. Then it just stopped starting completely and I would jiggle the terminal cables and sometimes it would start. I replaced the new starter again, cleaned the terminals real good, replaced all connections going...
  4. 9

    smoke is coming into center console

    My car just died and I imediately smelled smoke in the cabin, I tried cranking the car back over, nothing happened but then smoke started coming up around the E brake and center console. What the heck does that mean, obviously it has to be some sort of wiring problem, but what could cause all...
  5. 9

    Cobra T-56 in 94 GT

    My tranny blew up last week so I started looking into T-56's. The only one I can find in my price range is a rebuilt one from a cobra. Of coure Ford had to put the 27 spline output shaft in them, so my question is, is there anyway I can find a 27 spline yoke that will fit my driveshaft? Also...
  6. 9

    Tuning to pass inspection

    Today I just got back from failing an inspection in Texas after spending $600 on legal exhaust parts. I did very well on the mid-range rpm emission tests but on the idle i did horrible, with a standard of 220 my car got an 852. I have a tweecer and was wondering what changes i can make to my...
  7. 9

    blah

    blah
  8. 9

    A9L swap question

    I have a tweecer and have had trouble tuning and I am now considering the A9L computer and harness swap. Is this a good idea? Has anyone had success. thanks
  9. 9

    Question about aftermarket MAF's

    Im fixing to buy a new maf for my car and would like to know which one performs the best and will make my car run the best with my mods. Im using 24# injectors, N-41 cam, TFS intake and TW heads. I was looking at the pro-m 80mm and obviously calibrating it to my injectors. But what do yall...
  10. 9

    2 questions

    im looking for some way to remove the oxidation on my roof and hood, anyone have any suggestions? also what is a good long lasting wax? i have used the ntx wax and it just seems to not last long and ive noticed some of yall having the same results. thanks
  11. 9

    will I need to change my pushrod length

    im going to change my stock head setup and steeda#19 cam, to the anderson ford motorsport N-41 cam with pro-magnum roller rockers and TW heads. will i need to change my pushrod length?
  12. 9

    Help with cam selection

    I'm currently debating my cam selection for my stock shortblock 302. The heads will either AFr 165's or tfs twisted wedges. I'm looking at the Comp XE 270 and the Anderson N-41. I have a Tweecer so all drivability issues will be resolved through proper tuning. I currently have a TFS street...
  13. 9

    What do yall think about this set up?

    Twisted Wedge heads, trick flow stage 2 cam, pro-magnum roller rockers, either rpm2 or holley systemax although ive heard you cant use the holley on a stock hood, is this true? but anyway, id just like to get a few comments about this setup before i scoop it up. i already have a tweecer by the way.
  14. 9

    Need help with electrical problem

    my problem is that my blinkers dont work, everytime i use them the fuse blows. so, i narrowed the problem down to the drivers side, and the chiltons says that if one side is not working then its either a bad bulb or it says to check the grounds in both housings... my question is, where are the...
  15. 9

    What the hell is wrong with my alarm!?!?!

    I just got this thing installed, worked perfect now whenever I try to arm it it doesnt chirp, and the LED light doesnt blink it just stays on constantly. Which means the thing isnt being armed. I read the manual and when you lock the doors its suppose to make a chirping noise. btw it's the...
  16. 9

    I need a car alarm!!

    Just the other day I got off work to find all my stereo equipment gone(between 3-5pm albertsons parking lot). Insurance is going to cover it and should give me about a grand back. Before I replace anything id like to learn somethin about car alarms and pick out a good one, so this doesnt happen...
  17. 9

    car makes a squeeky noise over bumps

    When ever Im driving and cruise over any bumps my car squeeks, especially when it's weighted down with more people. It even does it when I accelerate. I've noticed it's coming from the rear of the car. I was thinking it's probablly a bushing or maybe some bearing.Has this happened to anyone...
  18. 9

    Questions for steeda #19 users

    I'm thinkin about getting the steeda #19 cam. Im going to be replacing some lifters and my harmonic balancer and timing chain. So I thought I mise well throw in a cam. Anything I need to know about it, like clearance problems with my pistons and stock heads. also will the swap be worth it?
  19. 9

    Bad fuel pump symptoms

    What are some symtoms of a bad fuel pump, or a fuel pump that can't put out as much fuel as your car needs. Right now I basically have long tubes, a trick flow street intake, and pulleys, and I ported out my stock heads a little. My car out of nowhere started popping under load and...
  20. 9

    What's this noise?

    My car is making a ticking/rattling noise. It sounds like its coming from under the valve covers or possibly my header. The sound does speed up with acceleration. I recently removed my heads and replaced them with another pair of e7's partially because of this problem, and of course the sound...
Top Bottom
Back
Forums
Menu