Search results

  1. Y

    t5 how much?

    How much should i expect to pay for a used t5 transmission now days?
  2. Y

    car stalls at idle after about 2 mins

    I have a 92 Gt that has been sitting in the garage under going an engine rebuild for a few years now:notnice: when i start the car it stalls after about 2 mins when just idling. I have replaced the coil and distrubutor(both msd). i disconected the msd ignition (6AL) and the car still does the...
  3. Y

    Mark VIII Fan 97-98

    I know the Mark VIII 93-96 models are three wire and the fan speed changes based on which black wire you connect. The Mark VIII fan for 97-98 models are two wire. My question is how do I change the speed of the 97-98 model fan or is this a two speed fan.
  4. Y

    high beam indicator

    When the key is off and i turn the headlights on, the high beams, low beams and flash to pass all work. But the high beam indicator does not come on... When the key is in the on position the high beam indicator stays on weather the lights are on or off. NOW MY QUESTION IS WHAT IS CAUSING THE...
  5. Y

    Turbo mounting question

    Does anyone have any info on doing a twin turbo setup where the turbos are mounted under the car where the headers and H-pipe meet.
  6. Y

    Which model t56 for t5 t56 swap

    which t56 works best for the t5 t56 swap in a 5.0, or does it matter which model you use for the swap:shrug:
  7. Y

    t-5 to t-56 swap (what do i need)

    What do i need to go from a t-5 trans to a t-56 trans??? do i need to change driveshafts, get the driveshaft cut, or just change the input shaft??? Can i use my same clutch or do i need one that is a different spline??? And lastly does anything need to be done to the crossmember like on a tko...
  8. Y

    Starter problem

    when i start the car the starter won't stop cranking unless i disconnect the battery cable. ignition switch is good. the starter relay is good. had the starter test and it was said to be good. what could it be?:shrug:
  9. Y

    trouble turning block by hand

    im trying to install stud mount rockers. in doing so i am turning the block by hand with a 3/8 ratchet, brakerbar, 16mm socket, and a 12'' extention. so far i have broken 2 craftman ratchets( not inhalf but the ratchet startes to slip after i put so much presure on it) and a 1/2 to 3/8 adapter...
  10. Y

    incon twin turbo kt

    does anyone know where i can get a incon twin turbo kit or atleast the headers for the kit
  11. Y

    incon twin turbo

    does anyone know where i can get a incon twin turbo kit or atleast the headers for the kit
  12. Y

    331 stroker victor jr heads?

    i have a 331 stroker that im putting together. this will be a twin turbo motor. i got a really good deal on some ported victor jr heads but im not sure if its to much head for my set up. is it too much head,if not what the best combo for what im trying to do?
  13. Y

    dart pro1 195 vs afr 185

    i have a 331 stroker that im putting together and i was planing to go with afr 185s. now that it has come down to me getting the heads im not sure which heads i should go with i saw specs for dart pro 1 195s and they seemed to be a go head. which is a better head, or is there a better out of...
  14. Y

    AFR heads

    can the afr 185s fit on the stock bottom end of a 302 with out notching the pistans? some one was telling me this was posable but you couldn't go any larger than an e303 cam. is this true or is he full of *****
  15. Y

    fuel pressure & Timing

    First i was wondering what stock fuel pressure was on a 5.0. im wondering this because i installed a 255lph intank fuel pump and i have an Aeromotive adjustable fuel pressure regulator on the way. I here that if you bump the timing up and fuel pressure you will gain a few ponies. what should...
  16. Y

    92 GT won't start

    I was backing up and my car just shut off. Im not getting gas or spark. so far i have changed the fuel pump and the distributer modual. at the fuel pump relay i get my constant 12 volts in and 5 volts( is 5 volts normal???) from the ignition to the relay and i know the relay is good what could...
  17. Y

    Help!!! Car stalls when i Pop the clutch

    When i pop the clutch at idle i get a small cherp and then my car will die :bang: or it will die down real low and then regain power :bs: . But the tires won't break loss for *****. the only way the tires will break loss is if i were to rev up and then pop the clutch. Any mustang should be able...
  18. Y

    BILLET ALUMINUM vs STEEL (pullies)

    What's the big difference between ALUMINUM pullies and STEEL pullies? :shrug: I one better than the other. Help me understand. :spot:
  19. Y

    manual rack conversion

    if i were to go to the juck-yard and get a manual rack out of a 79-81 mustang would it bolt straight up to my 92 Gt, and would i need a steering shaft made for a manual rack? Is there any other car I can get a manual rack off of? and if the rack were out of the junk-yard would it need to be...
  20. Y

    broke screw extractor in a broken bolt

    i have a broken bolt that i am tring to get out of my crank shaft :notnice: ( balancer bolt) so i tried to drill it and then use a screw extractor on it. once i got the hole big enough for the extractor i put the extractor in and it broke off in the hole that i drilled in the broken bolt :bang...
Top Bottom
Back
Forums
Menu