Search results

  1. P

    Need TB adn EGR Spacer Gaskets..

    I have an explorer TB, and a 65MM BBK Spacer. But if i remember correctly the Exploders didn't have a EGR Spacer so can i just buy the two gaskets for a 93 cobra and call it good? arn't they 65MM TB adn Spacer?
  2. P

    Running To Cool?

    What temps are a little high?
  3. P

    Running To Cool?

    New WP, 3 row radiator, and elec fan. 190 isnt really a high temp from what i read/hear so i think i'll just leave it and go with...if it aint broke dont fix it :D
  4. P

    Running To Cool?

    Went and bought the correct adaptor today and it runs a constant 189-191ish... is this correct with a 180* thermostat?
  5. P

    Running To Cool?

    what about people that use T fittings to keep the stock gauge working...isn't this the same concept? Regradsless i ordered the correct fitting it'll be here friday
  6. P

    Running To Cool?

    good enough a second opinion always makes your feel better about your self i'll order the adapter tomorrow
  7. P

    Running To Cool?

    i just installed an autometer sport comp mechanical coolant gauge in my car. I bought the gauge used to the only fitting i had was 1/2". So to get it to fit the intake i had to put a threaded pipe in the intake screw on a 1/2"-3/8" reducer then the probe on top of that...so the fittings stick...
  8. P

    Tach Pod install...where to route gauge lines?

    last question...how did u get the shift light wires in the pod...my shiftlight doesn't seem to detatch?
  9. P

    Tach Pod install...where to route gauge lines?

    Anyone with the Tach pod for the Fox Bodys...where did u run your gauge lines? i have a coolant temp and oil pressure...
  10. P

    Correct Oil Pressure fitting?

    I just ordered some gauges, and was wondering if this was the correct fitting for the Oil pressure...
  11. P

    GT-40P Heads + B Cam + 1.7s = ??

    while this combo work? do i need longer pushrods if so what size? also will the springs be ok? or do i need new ones too? Isnt a B cam with 1.7s a 512/512 lift? Thanks I'll be ordering all this next week
  12. P

    245/60/15's- will they fit?

    they'll fit i ran 255-60-15s on 10 holes. rubbed the inside fenderwell and tail pipes under hard cornering...IE donuts
  13. P

    Dyno #'s AOD to T-5 Swap

    i shaved off .4 in the 1/8 with t5 over C4
  14. P

    VC Gaskets / Upper Intake Removal

    I've never done this before, so i'm guessing i have to remove the upper intake to get the driver side VC off... How do i do this, just un bolt the 6 bolts and off comes the intake?
  15. P

    Car runs good until it sits and idles...

    I've noticed a little power loss latly....but if you get stuck at a light the car runs really bad...has a miss to it and the intake pops...but if you turn it off and back on its fine until it has to sit and idle again... Any ideas?
  16. P

    Car runs bad after idleing!?!

    ttt
  17. P

    Car runs bad after idleing!?!

    I also noticed when i rev the car a little...when i goes back to idle it drops to about 500 then goes back to ~800 with its idles....so it rev and let off it goes to 500 then up to 800... if that has anything to do with the problem stated above IDK lol
  18. P

    Car runs bad after idleing!?!

    After a long road of R&R parts...the car is running noticable better after a new alternator (stock) Voltage didn't seem to change to much but the old one test to have a bad Diode. But now you can go out and drive and its fine. But if you have to stop at a light when you take off it has a...
  19. P

    Alternator Diode BaD!?

    so that means my alt is bad? i want to get a better AMP one w/o having to modify the alt bracket
  20. P

    Alternator Diode BaD!?

    I went to Autozone and did a onthe car alternator test (bc my volt meter reads low). Stays its charging the battery but its only putting out 12V...so it could be the voltage regulator. Ok i go home take off the alternator put a new regulator on it, and take it to Advance for a bench test...
Top Bottom
Back
Forums
Menu