lifters

I need help from the Ford gurus because my 1965 Mustang has officially become possessed. The build: 1965 Mustang SN95 5.0 roller block Trick Flow 11R Top End Kit from TRE Holley Multi-Port EFI intake Holley Terminator X Max LU47 injectors T5 transmission Confirmed correct 7.050" pushrods More...

There was clacking under my valve cover took it off and some of the rockers were loose so I bought all new pushrods,lifters, and valve springs all stock sizes . Putting it back together everything is torqued but all the rockers are loose except for the ones with the lifters that are fully pushed...

I just replaced a questionable lifter from my engine with a Summit Racing SUM-HT220 lifter, and it is ticking. It was soaked in oil overnight before installing. I can very easily press down the lifter by pushing down on the rocker arm. Oil pressure is 19 at hot idle, but that should be more than...

Ticking right up under the driverside valve cover, gets quicker with rpm, and sometimes you hear a flutter of around 5 in a row instead of just a single tick. I have already pulled the lifters and pushrods out and checked and they looked fine also no loose rocker arms. I have also tried thicker...

Been in the middle of replacing my 4.6Ls head gasket on a 97 GT. Before I started the work, the engine did have a ticking noise that was getting worse as time went on. I ran it for about a month and a half with that tick, and by the time I was starting the head job, the ticking was real loud...

[SOLD] Listed are Ford 5.0/302 roller lifter Valvetrain/Cam components including: lifter guide plates, guide plate retainers "spider", roller lifters, and pushrods. There are 16 roller lifters (+1 spare for a total of 17). I was actually collecting these parts for a 302 I was going to put in a...

alright so a couple months ago I had the misfortune of blowing up my 5.0 (crank snapped...picked timing chain up off street) and when we were taking the cam out we noticed that it seemed kind of hard to pull the cam out of the first set of cam bearings, after that it came out perfectly...when...

In my 98 GT, it makes a kind of a ticking noise, it kinda sounds like it comes from the rear of the valve cover, it gets loud then goes away and come back again, once the car has fully warmed up it stays away until its shut off and cools down a little bit. Could be a valve lash adjuster? Or what?

Hey everyone new here just wondering if anybody can offer some help on some issues. So a couple weeks ago my car overheated on a really hot day during a 2 hour road trip from picking up my sister from her moms. I was about 45 minutes from home and my car went from O on "normal" to the red zone...