• Tags

vibration

  1. J

    Bad Vibration

    Hi all have a 2000 Mustang Base 5spd and having a shaking and vibration issue. Small backstory on the car bought it for 300$ running and driving leaking transmission fluid. Come to find out when home the tail housing on the t5 was cracked so I took it out out in a same year t5 out of another...
    • jefffletch47
    • Thread
    • Feb 12, 2026
    • motor mounts vibration
    • Replies: 7
    • Forum: 1996 - 2004 SN95 Mustang -General/Talk-
  2. S

    Drivetrain 8.8 Pinion and 302 rear main seal leaks after replacing. 93 5.0 with t-5

    93 5.0 with 8.8 rear and t-5. Hey guys I have a few questions. Just replaced my pilot bearing, rear main, flywheel pressure plate and clutch, throw out bearing and clutch fork and pivot stud, trans output seal, new rubber motor mounts, prothane trans and crossmember mounts, new u joints, pinion...
    • Steigy4827
    • Thread
    • Jun 23, 2025
    • 5.0 8.8 ford leak pinion t-5 vibration
    • Replies: 10
    • Forum: Fox 5.0 Mustang Tech
  3. J

    Severe shaking/vibrations in steering wheel

    hey there everyone! hope y’all are doing better than i am. i’m having serious trouble with my 2003 Mustang V6 Convertible. since purchasing this car at 98,000mi. i’ve had a consistent vibration in the steering wheel, and more. at 35mph and below, there are light vibrations and movement in...
    • jacket999
    • Thread
    • May 20, 2025
    • shake steering steering wheel vibration suspension vibration wheels and tires
    • Replies: 8
    • Forum: SN95 V6 Mustang Tech
  4. U

    8 Years of Vibration leading to engine knock?

    I appreciate any help I can get. 8 years go a family member replaced the 3.9L motor in my 2004 Mustang. Ever since then there has been a vibration at idle when in drive and foot on the brake. It feels rhythmic where the vibration frequency ramps up to a point then slowly goes back down and...
    • UpgradeXP
    • Thread
    • Apr 14, 2025
    • chirp knock sound vibration
    • Replies: 3
    • Forum: SN95 V6 Mustang Tech
  5. R

    Bad Vibration at 2000-3000RPM

    Ok I’m stumped. 1995 mustang v6 car converted to 5.0 I pulled the block this fall and took it down to the bare block. Got it bored .030 over, like honed, new plugs, cam bearings decked the block and got a scat street/strip 347 stroker kit installed. Here’s the rest… 347 stroker Ford F303 Cam...
    • Rona
    • Thread
    • Apr 16, 2022
    • 347 stroker sbf vibration
    • Replies: 29
    • Forum: Fox 5.0 Mustang Tech
  6. Engine 2000 RPM Vibration

    I've got a vibration between 2000-2400 RPMs that gets worse with clutch engaged. It does it in all gears going any speed, or revving. It gets worse with load too. Not quite sure what it could be. I can feel it the most when I rest my hand on the shifter. Balancer? Clutch plate? Trans input...
    • 93CalypsoConvert
    • Thread
    • Oct 30, 2021
    • engine vibration
    • Replies: 28
    • Forum: Fox 5.0 Mustang Tech
  7. Deep vibrating sound coming from back of car while decelerating at high speeds.

    I own a 1986 GT and I have noticed that when driving on the freeway going 70 mph or higher, after I release the gas pedal to slow down a bit I hear a deep vibration noise coming from the back right wheel area. It sounds like something is whining but it is a very deep tone. The car leaks brake...
    • opihinalu
    • Thread
    • Feb 18, 2021
    • help please noise vibration
    • Replies: 2
    • Forum: 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  8. T

    2014 Mustang GT vibration

    My 2014 GT has a vibration when letting off the gas coming from right below the shifter it has the MT-82 trans has anyone else had this problem it’s only when decelerating
    • Tomferd804
    • Thread
    • May 1, 2020
    • 2014 mt-82 vibration
    • Replies: 0
    • Forum: 2010 - 2014 Specific Tech
  9. R

    3rd gear pedal down vibration

    Hey guys, I am new to the Cobra world. I purchased a 2004 cobra convertible about a month ago. I knew it needed a few things because it sat for so long. there was a loud howl from the rear so I just had a shop rebuild the gears in the rear with stock 3.55 its perfect. super quiet. There was also...
    • rsmith42589
    • Thread
    • Apr 8, 2020
    • cobra shake vibration
    • Replies: 0
    • Forum: SVT Tech Forum
  10. M

    Drivetrain Vibration In Every Gear T-5 Tremec!

    Okay, been chasing this issue for awhile, previous owner says its a rebuilt t5 with 5k miles on it. After driving it for a few months i was going about 50 dropped it to third and gave it hell. after that i had blown my coolant hose off and over heated. pulled over put it back on, took off and...
    • marxpreston11
    • Thread
    • Dec 2, 2019
    • 5.0 foxbody 5.0 help! jrichker. anyone. i'm stumped imonly19andneedhelp t5 transmission tremec t5 vibration
    • Replies: 5
    • Forum: Fox 5.0 Mustang Tech
  11. D

    Suspension S197 Clunking/rattling sound when accelerating and turning right?

    Alright I have been chasing the cause of this noise since I got the car 5 years ago. The noise started showing up when I would be turning right with the car in 3rd gear at about 1800rpm. If I were to push the clutch in, the noise would go away. If I revved the engine to ~1800 rpm in neutral...
    • Dingo7222
    • Thread
    • Jun 3, 2019
    • clunk rattle s197 steering vibration
    • Replies: 2
    • Forum: 2005 - 2009 Specific Tech
  12. T

    2008 Mustang GT Vibration in Entire Car

    Hey guys :), really looking to get to the bottom of this... I had taken my car to my local Gerald's who do good work. And they checked my entire front end. Called me and said that the passenger outer tie rod was shot, driver inner tie rod shot, bushings for my front suspension shot, front/rear...
    • TacoHD
    • Thread
    • Apr 10, 2019
    • aluminum driveshaft driveshaft front end help rear end gears s197 vibration
    • Replies: 5
    • Forum: 2005 - 2009 Specific Tech
  13. D

    Harmonic Balancer

    Is there a difference between a harmonic balancer for a standard transmission vs. an automatic transmission? I have a 2001 v6 with an automatic and when I purchased this vehicle they threw in another motor that was a manual configured for a manual transmission (I only know it was manual...
    • dml1964
    • Thread
    • Mar 14, 2019
    • vibration
    • Replies: 1
    • Forum: 1996 - 2004 SN95 Mustang -General/Talk-
  14. M

    After header install Vibration in idle and gets worse when in gear help

    Hello everyone i've got a bit of a weird issue that I can't seem to figure out. I recently brought my car into a shop to get my shorty headers installed after my DIY failed attempt caused the EGR seal to break and that came with check engine lights and running lean codes and I just gave up...
    • MustangsForEver
    • Thread
    • Nov 4, 2018
    • headers vibration
    • Replies: 1
    • Forum: 2010 - 2014 Specific Tech
  15. D

    98 Rough idle and ride after motor and tranny mounts

    Hi there, Strange question, I had both motor mounts and tranny mount put in my mustang last week. I noticed right away when I got in the car and started it up that I could feel a crazy vibration in my seat and in the steering wheel that wasn't there before. While accelerating, I notice a large...
    • dchall89
    • Thread
    • Aug 23, 2018
    • idle motor mount transmission mount vibration
    • Replies: 2
    • Forum: SN95 V6 Mustang Tech
  16. K

    3.8l Vibration - Engine Swap

    Hello, A while back i bought a 2002 mustang (base) 3.8 automatic for $400 on craigslist, it ran and drove fine besides the 2 spun rod bearings. I went to the local pull-a-part and bought another 3.8 from a 2000 mustang that was a 5spd. I swapped over all the 2002 sensors onto the "new...
    • king_ranch
    • Thread
    • Jan 14, 2018
    • balancer transmission mount vibration
    • Replies: 5
    • Forum: 1996 - 2004 SN95 Mustang -General/Talk-
  17. W

    Foxbody Vibration At High Speed

    So this is my third post about this and I haven't fixed it yet. After a clutch job two summers ago I've had this horrible vibration at high speed not rpm dependent just speed dependent. We bought the flywheel from oreilys we changed everything but we did not change the pilot bearing or atleast...
    • Wetblanket
    • Thread
    • Dec 16, 2016
    • clutch job foxbody help vibration
    • Replies: 47
    • Forum: Fox 5.0 Mustang Tech
  18. Vibrations

    Hi, New to this forum. Wondering if anyone would have any suggestions on a vibration that is felt from 2300rpm+ which is making my car pretty unbearable to drive at any speed above 45.. I've replaced the ujoints front and rear on the driveshaft this past summer. Tires are "fairly" new but it...
    • 1970GrabberCoupe
    • Thread
    • Nov 23, 2016
    • 1970 302 auto scary shakes vibration
    • Replies: 6
    • Forum: 1965 - 1973 Classic Mustangs -General/Talk-
  19. 2004 3.9 V6 Engine Vibration

    I have been having some engine vibration for about a week now and I can't seem to figure it out. The whole engine shakes in idle and throughout the rpms (though it is worse around 1200 rpm). It also has a cough coming out of the back right tailpipe. There is also a rapid clicking type noise...
    • Russell P
    • Thread
    • Oct 17, 2016
    • 2004 3.9 cough rpm rumble shake vibration
    • Replies: 0
    • Forum: SN95 V6 Mustang Tech
  20. 2004 3.9 V6 Bad Engine Vibration

    I have been having some engine vibration for about a week now and I can't seem to figure it out. The whole engine shakes in idle and throughout the rpms (though it is worse around 1200 rpm). It also has a cough coming out of the back right tailpipe. There is also a rapid clicking type noise...
    • Russell P
    • Thread
    • Oct 16, 2016
    • 3.9 cylinder engine help mustang six vibration
    • Replies: 0
    • Forum: 1996 - 2004 SN95 Mustang -General/Talk-
  • 1
  • 2
Next
1 of 2 Next Last
  • Tags
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?