wont start

  1. C

    Foxbody with no start issues

    Looking for some help or advice. I've just recently rebuilt my 1991 LX with a 408 stroker motor and MSD ignition system, and Aeromotive Fuel System. Here is what has been done so far: Verified fuel pressure running around 42PSI, and the motor has great compression, problem seems to be with the...
  2. G

    96 GT cranking but won’t start

    I just recently got a 96 gt and it’s having an issue where it will crank fine but not start. I tested the battery and alternator and they are putting out plenty of power. The fuel pumps are also working as they should. The guy I bought it from said that when he got the car the previous owner...
  3. C

    92 fox 5.0 won’t fire, pump issue?

    What tells the fuel pump to shut off after priming? When I cycle the key on, The pump turns on and never shuts off. Bad pump? 1992 mustang GT 5.0 Will fire /Run on starting fluid has spark, correct plug order Ignition switch replaced Has 40 or so psi at the rail Injectors are getting 12v off...
  4. M

    Head intake V3 install

    Hi all, just installed new stock heads with Trickflow valvetrain components, GT40 intake, and new Vortech v3 supercharger. Only thing l can tell that's unaccounted for is this plug, which is not connected. Just tried to start her, and she cranks but doesn't start. Sounds like a muffled...
  5. J

    Engine 1989 Fox GT 5.0 - wont start after CAI and Throttle body upgrade. HELP!

    Hey all, Been referencing stangnet forums for a while but finally joined. First forum post ever so bear with me. I have a 1989 Mustang GT 5.0 convertible that i recently got and have been upgrading here and there. Iv run into a problem and could use some help from you all. Yesterday i...
  6. M

    Misfire Hesitation And Popping Sounds

    Hey, so I have a 2003 mustang gt and I seem to have problems with it starting up and running. So first off the car runs but it hesitates and misfires. So I'll have the car in 2nd gear and I'm cruising at say 2200rpm and then I floor it and it just starts to spit a chug and pop sometimes. Also it...
  7. jon_95GT

    SN95 Trouble Starting Out Of No Where

    Hey guys, ok so over the last 2 days i did both ball joints swapped them for the steeda x2s. this morning i started my car and took it for a drive to see how it felt, well i noticed on my test ride my oil temp was all the way to H and my battery wasnt charging. I got to the store cause i needed...
  8. C

    Cleaned Egr Valve Now My Car Wont Start.

    Hello guys. I have a 2001 3.8 stang. 115,xxx miles. So recently it was time to get my tags and i had a check engine light went to my local autozone and the code that came up was p0401 egr flow insufficient. First thing i did was change the egr sensor then reset the code. Car worked fine the code...