06 mustang balancer

1

1fastz

Member

Sep 30, 2005

124

0

16

Oct 8, 2005

#1

• Oct 8, 2005

• #1

For some reason my 06 mustang has NO HOLES drilled in the harmonic balancer to use a puller on it.

is this normal did ford go to a special tool for 2006 for the balancers ?

there realy is no way to pull this balancer short of drilling and taping the holes in the three arms.

however there is no way im getting in there to drill the holes without removing the radiator etc.

 

tom281

New Member

Jun 25, 2005

253

0

0

NE Indiana

Oct 8, 2005

#2

• Oct 8, 2005

• #2

I'll have to check that out on mine too! Thanks for the heads up. If mine does have holes, I'll post back to let you know.

tom281

 

J

JST4FN

New Member

Apr 4, 2005

12

0

0

Oct 8, 2005

#3

• Oct 8, 2005

• #3

Nope they do not have holes for you to pull with. You will have to get a puller that has fingers that pull on the backside of the balancer. I hope that helps.

Thanks Mike

 

1

1fastz

Member

Sep 30, 2005

124

0

16

Oct 8, 2005

#4

• Oct 8, 2005

• #4

gah taht sucks i have one of those but the balancer is so close its a pain in the arse to use

 

mpentico

New Member

Dec 7, 2004

181

0

0

Oct 8, 2005

#5

• Oct 8, 2005

• #5

My 05 also did not have holes!

I used a standard puller with an old socket as a spacer.
It was a tight fit, but no need to remove the radiator.

Ford really blew it on this little detail.

And the balancer was nearly WELDED ON... it took a whole lot of pressure and even some heating up to get it to break free.

GOOD LUCK!

 

1

1fastz

Member

Sep 30, 2005

124

0

16

Oct 8, 2005

#6

• Oct 8, 2005

• #6

bah none of my pullers would work im going to picjk one up tomorrow

on the plus side it dynoed 302 rwhp 321 rwtq with out the pullyes

just the cat back c and l cold air tune and the imrc elimnator plates

 

Motorhead6T5

New Member

Oct 21, 2004

215

0

0

Marysville,CA

Oct 9, 2005

#7

• Oct 9, 2005

• #7

It's way easier to use a 3 prong puller with the E-fan out of the car.