180 Thermostat problem?

menasci

Member
Aug 17, 2003
640
1
16
Chandler, AZ
I installed a 180 degree thermostat.
It didn't have any markings for which way it should face.
It seems to open just fine.
I even tested it in a pot of hot water to watch it open, and it did.
I installed the T-stat and place the new rubber gasket on top of it and then tightened the housing on top.
It works but I see a tiny tiny bubble popping out of the housing.
Any ideas why this is happening?
There are no cracks or anything in the housing.