I installed a 180 degree thermostat.
It didn't have any markings for which way it should face.
It seems to open just fine.
I even tested it in a pot of hot water to watch it open, and it did.
I installed the T-stat and place the new rubber gasket on top of it and then tightened the housing on top.
It works but I see a tiny tiny bubble popping out of the housing.
Any ideas why this is happening?
There are no cracks or anything in the housing.
It didn't have any markings for which way it should face.
It seems to open just fine.
I even tested it in a pot of hot water to watch it open, and it did.
I installed the T-stat and place the new rubber gasket on top of it and then tightened the housing on top.
It works but I see a tiny tiny bubble popping out of the housing.
Any ideas why this is happening?
There are no cracks or anything in the housing.