Selling this 1968 Ford mustang drag race car. This car is turn key and ready to run. It is a tube chassis car equiped with a 9" rear and 35 spline mark williams axles and spool, and Ladder bar rear end, This mustang has run a best 10.06@134mph with a 1.34 60ft. No power adders.
Powered by a very mild 460 and backed buy a built c-6 trans. The motor is a very healthy 460 bored .030 with forged pistons, it makes aprox. 550hp, the car runs on pump gas. The transmision is a c-6 with an ATI full manual reverse valve body, with trans brake and a 34 stall Torque. Brakes consist of disk up front and drum at rear, Car stops great. Steering is pinto manual rack. Wheels are weld on all 4 corners, with new front runners and very decent rears .
The mustang runs arrow straight, transfers perfectly and is an awsome bracket car. The car is equiped with full electronics and safety equipment. Nothing but the best went into this car when it was built.
Amazing potential as this car will easily run the 9's or faster.There is too much to list so please call or email with any questions.
The body is in very nice condition, presently sitting on black epoxy primer.Asking $12000.00 or b/o
You could not build the frame for this amount of money
George (514) 409-6349 or [email protected]
Powered by a very mild 460 and backed buy a built c-6 trans. The motor is a very healthy 460 bored .030 with forged pistons, it makes aprox. 550hp, the car runs on pump gas. The transmision is a c-6 with an ATI full manual reverse valve body, with trans brake and a 34 stall Torque. Brakes consist of disk up front and drum at rear, Car stops great. Steering is pinto manual rack. Wheels are weld on all 4 corners, with new front runners and very decent rears .
The mustang runs arrow straight, transfers perfectly and is an awsome bracket car. The car is equiped with full electronics and safety equipment. Nothing but the best went into this car when it was built.
Amazing potential as this car will easily run the 9's or faster.There is too much to list so please call or email with any questions.
The body is in very nice condition, presently sitting on black epoxy primer.Asking $12000.00 or b/o
You could not build the frame for this amount of money
George (514) 409-6349 or [email protected]
