1989 Mustang LX Coupe. Dark grey with grey/black interior. This is a roller only and has no motor or transmission. It does have:
Complete interior
Power windows
Power locks (needs actuator)
Air Conditioning
Just had brand new AC condenser installed
Compressor is stilled hooked up and has a full fresh charge
Sound deadening on entire floor
New black carpet
The car has lots of new parts and upgrades that are worth more than what I'm asking for the whole package.
8.8 rear end with Auburn Pro Posi with 4.10 gears
Full 5-lug conversion on front and rear
Draglites 15x8 rear and 15x3.5 front
Brand new 255/60/15 Mickey Thompson ET Street drag radials
Through the floor subframe connectors installed
Torque boxes welded up
Manual steering rack
Offset rack bushings
Steeda bump steer kit
In-tank fuel pickup with AN fittings
Steel braided fuel lines
Adjustable clutch quadrant
Also includes complete EFI engine harness and A9L computer already on the car.
The bumpers have a couple of spots where the paint is chipped some. It also has a spot on the passengers side front fender thats dented. I do have a clear blue Tx title in hand (in my name). All you need is a motor, transmission, fuel pump, and exhaust and you're ready to go.
I'll take the first $3500 for everything listed.
I do have a T-5 (5-spd) transmission, complete 5.0 EFI motor, mass air meter, and radiator I'll throw in for another $500 if you buy the car. The motor was run low on oil so I'm not completely sure what all it needs.
Does have a 160 mph speedo too
View attachment 144109
View attachment 144117
Complete interior
Power windows
Power locks (needs actuator)
Air Conditioning
Just had brand new AC condenser installed
Compressor is stilled hooked up and has a full fresh charge
Sound deadening on entire floor
New black carpet
The car has lots of new parts and upgrades that are worth more than what I'm asking for the whole package.
8.8 rear end with Auburn Pro Posi with 4.10 gears
Full 5-lug conversion on front and rear
Draglites 15x8 rear and 15x3.5 front
Brand new 255/60/15 Mickey Thompson ET Street drag radials
Through the floor subframe connectors installed
Torque boxes welded up
Manual steering rack
Offset rack bushings
Steeda bump steer kit
In-tank fuel pickup with AN fittings
Steel braided fuel lines
Adjustable clutch quadrant
Also includes complete EFI engine harness and A9L computer already on the car.
The bumpers have a couple of spots where the paint is chipped some. It also has a spot on the passengers side front fender thats dented. I do have a clear blue Tx title in hand (in my name). All you need is a motor, transmission, fuel pump, and exhaust and you're ready to go.
I'll take the first $3500 for everything listed.
I do have a T-5 (5-spd) transmission, complete 5.0 EFI motor, mass air meter, and radiator I'll throw in for another $500 if you buy the car. The motor was run low on oil so I'm not completely sure what all it needs.
Does have a 160 mph speedo too
View attachment 144109
View attachment 144117