1991 GT Vert…Reinstalling removed factory A/C

Need a pic to see if oyu have the Power steering relocation kit, but generally you need these brackets to reinstall the a/c compressor.


There is an A/C subharness that plugs into a plug down near the coil under the starter relay.

And then there is a plug that plugs into the low pressure switch on the accumulator bottle on pass side firewall area. Plug should be dangling. that's really it for electrical.

No e fan in 1991. If oyu are missing the condensor mounting brackets, those are here.


I would highly recommend all new lines, or flush the parts that you end up reusing. Any dirt/corrosion/etc inside can clog the system up quickly. Cleanliness is critical.

The plug near the dist is the SPOUT plug used for setting timing. That’s not it. Look near the starter relay underneath. The ac harness is actually a 2 foot sub harness that plugs into the main harness there. Round connector. 2 pins. Black.


The other pic by the fireall is slightly offset to the right. Look about 6-8” to the left side and the plug should be around there.

Little dark but this is about where it is. Comes out of the main harness in this spot

Also, your accessory brackets on there now are the ford OE brackets for no a/c cars. You will need to purchase the above kit (or find OE brackets) as the ac compressor brackets will mount like this.

(Ignore the power steering reservoir)

Unfortunately no hood way to show the line routing. Too much stuff in the way.

Some in progress pics you can kinda make out the routing.