• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-

1997 Gt Electrical/tranny Problems

  • Thread starter Thread starter Bill Schippert
  • Start date Start date Jan 26, 2018
B

Bill Schippert

New Member
Jan 25, 2018
5
0
1
Jan 26, 2018
#1
  • Jan 26, 2018
  • #1
Ok. I bought a 1997 gt automatic. Had the car a month then one day it wouldn't turn over. After a few tries she fired up. I drove her 30 miles and noticed aod light flashing. So I stopped obviously to check tranny fluid. It was fine. Went to start back up and again it wouldn't turn over. I used my phone and trouble shooter. Its proofing out so no trouble with PATS. Finally I just jumped her at starter. Now the damn thing won't shift past 2nd. Not the end of the world because she was gonna get a
stage2 tranny but I'm not spending a penny till I figure out what I'm dealing with. Where would I start?
 

wmburns

SN Certified Technician
Aug 14, 2009
5,892
514
204
Houston Texas
Jan 26, 2018
#2
  • Jan 26, 2018
  • #2
It's not clear to me if this is a "no crank" or "crank with no start" problem.
 
B

Bill Schippert

New Member
Jan 25, 2018
5
0
1
Jan 28, 2018
#3
  • Jan 28, 2018
  • #3
wmburns said:
It's not clear to me if this is a "no crank" or "crank with no start" problem.
Click to expand...
No crank... Absolutely nothing but fuel pump
 

General karthief

wonder how much it would cost to ship you a pair
Mod Dude
Aug 25, 2016
28,051
10,676
213
polk county florida
Jan 28, 2018
#4
  • Jan 28, 2018
  • #4
So your say'n the starter will not turn the engine and you can hear the fuel pump running, right?
 

wmburns

SN Certified Technician
Aug 14, 2009
5,892
514
204
Houston Texas
Jan 28, 2018
#5
  • Jan 28, 2018
  • #5
Giving the problems you are having with the transmission my vote is the automatic transmission DTR range shifter is out of adjustment. Such that when the gear shift level says "park" the DTR on the transmission is not actually in park.

If the problem is the neutral safety circuit (NSS) then jumping the R/LB and W/PK wire on the DTR connector should allow the starter motor to engage. Be careful to set the parking brake and block the wheels just in case the car were to move.

Another way to test the NSS circuit is to pull the starter relay from the engine bay. Using a test light or VOM test for +12 volts at W/PK (pin #85) with the key in the "crank" position.
 
B

Bill Schippert

New Member
Jan 25, 2018
5
0
1
Jan 28, 2018
#6
  • Jan 28, 2018
  • #6
karthief said:
So your say'n the starter will not turn the engine and you can hear the fuel pump running, right?
Click to expand...
Yes. Fuel pump runs, key proofs out but nothing. Not a click.
 
B

Bill Schippert

New Member
Jan 25, 2018
5
0
1
Jan 28, 2018
#7
  • Jan 28, 2018
  • #7
wmburns said:
Giving the problems you are having with the transmission my vote is the automatic transmission DTR range shifter is out of adjustment. Such that when the gear shift level says "park" the DTR on the transmission is not actually in park.

If the problem is the neutral safety circuit (NSS) then jumping the R/LB and W/PK wire on the DTR connector should allow the starter motor to engage. Be careful to set the parking brake and block the wheels just in case the car were to move.

Another way to test the NSS circuit is to pull the starter relay from the engine bay. Using a test light or VOM test for +12 volts at W/PK (pin #85) with the key in the "crank" position.
Click to expand...
Ok I'll try the new circuit. That might help with starting it but what about it not shifting past 2nd?
 
B

Bill Schippert

New Member
Jan 25, 2018
5
0
1
Jan 28, 2018
#8
  • Jan 28, 2018
  • #8
karthief said:
So your say'n the starter will not turn the engine and you can hear the fuel pump running, right?
Click to expand...
I've checked the PATS system and my key proofs out. It just does nothing. I don't think its the NSS but I'm rechecking it.
 

wmburns

SN Certified Technician
Aug 14, 2009
5,892
514
204
Houston Texas
Jan 29, 2018
#9
  • Jan 29, 2018
  • #9
Then test for +12 volts at the Transmission R/LB wire with the key in the "crank" position. Use a KNOWN good ground. Where to focus next depends upon the test result.
 
You must log in or register to reply here.

Similar threads

S
Crank no start, I’m stumped!
  • Seth Brogan
  • May 18, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
10
Views
1K
1996 - 2004 SN95 Mustang -General/Talk- May 14, 2026
BossHorseGirl
B
Place to Avoid: Jamison Auto Group in Gulfport, MS
  • D Durden
  • Oct 20, 2025
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • 2 3
Replies
46
Views
3K
1965 - 1973 Classic Mustangs -General/Talk- Jul 16, 2026
Noobz347
G
Resolved Please help! (starting issue)
  • Ghoste
  • May 11, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
7
Views
525
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- May 11, 2025
Ghoste
G
1999 Mustang GT - No Start- Need help understanding the fuel pump circuit and how it works
  • 99gtGuy
  • Nov 4, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
1
Views
579
1996 - 2004 SN95 Mustang -General/Talk- Nov 7, 2025
04newedge-
0
K
Engine 2000 Mustang GT - Fuel issue post-blown spark plug repair
  • kenster1092
  • Feb 26, 2026
  • SN95 4.6L Mustang Tech
Replies
4
Views
457
SN95 4.6L Mustang Tech Mar 10, 2026
kenster1092
K
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?