I got bored yesterday and decided to install my new plenum and throttle body. It was a fairly easy job and only took 30 minutes at most, but I'm extremely anal when working on my car. The only difficult part was getting the stock intake hose for the 65mm TB to fit on the 75mm TB. Had to whip out the KY and use a lot of force to finally get it on.
I haven't been able to drive the car due to the "Great Flood" we're working on, so I don't know if there is a SOTP gain. But, there have been so many positive posts on these parts I'm not too worried about that.
My questions are as follows:
1. Where should my car be idling? The diagnostic function for the tach shows between 820-845RPM or so. I didn't look at it before I installed the stuff and only checked after
2. My car has always had the "hanging idle" when letting off the gas. Now, while the car was idling I revved it a few times and it hangs longer now. What can I do about that?
I haven't been able to drive the car due to the "Great Flood" we're working on, so I don't know if there is a SOTP gain. But, there have been so many positive posts on these parts I'm not too worried about that.
My questions are as follows:
1. Where should my car be idling? The diagnostic function for the tach shows between 820-845RPM or so. I didn't look at it before I installed the stuff and only checked after
2. My car has always had the "hanging idle" when letting off the gas. Now, while the car was idling I revved it a few times and it hangs longer now. What can I do about that?