• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

2000 GT in need of brakes/rotors

  • Thread starter Thread starter Nazaar33
  • Start date Start date Jun 17, 2004

Nazaar33

Founding Member
Feb 20, 2002
401
0
0
In my 2000 Supercharged GT - Raleigh, NC
Jun 17, 2004
#1
  • Jun 17, 2004
  • #1
2000GT Brake Q'S.

Hi everyone,
Its been too long since my last post..so Hello to all the guys I do know.

I have a 2000 GT..which still has the STOCK pads & STOCK rotors!
I have 86,000+ miles on my supercharged GT! Those brakes lasted forever!

Anyways...the shoes are completely shot/gone. The rotors in the front are under specs (so they need to be replaced) and the rear rotors are slightly over spec...but one of them has a slight groove..so it will have to be resurfaced at the least. I would like to make a slight upgrade w/out spending too much money...and wanted some suggestions and ideas from you guys.

I was thinking..for the rear...I want to replace the pads..and will most likely...turn and resurface the rear rotors. I think they rotors will be just over specs...and should last for awhile...since they are on the rear..and the front ones are the one that take the majority of the braking wear/tear.

For the front...I think I should replace the rotors...but am not sure if I should replace them w/ the stock rotors..or should I maybe get some 13 inch rotors.
From what I understand...I am able to have 13" rotors up front..and 12" rotors in the rear, right?
If I do get some rotors...I'm not sure where the best places are to purchase them..so that I am getting a good deal on some good quality 13" rotors.

One additional question I had was whether the calipers are normally replaced when you replace brake shoes...or after 86000 miles? If I should replace the calipers...I was thinking of getting some like the ones I saw on discsareus.com. They were silver coated powder w/ the pony emblem on them. I thought they looked good. In fact..I saw a front kit on there for about $600...but I wasn't sure if the rotors were included in it or not?
And if I get the front two calipers like that..then I'll have to get the rear two calipers.

Anyways..i'm looking for some guidance from the people that I know hold a wealth of knowledge...which i've found from past experience.

If anyone & everyone could please respond w/ their suggestions..I would greatly appreciate it.

Thanks,
Y2KPONEY
 

stallion98gt

New Member
May 12, 2003
1,802
0
0
Los Angeles, CA
Jun 17, 2004
#2
  • Jun 17, 2004
  • #2
since ur GT is supercharged.. I stronlgy advice upgrading the brakes !!!!..ur car is out of specs anyways...since ur pushing way more than a stock GT...I would recommend BREMBO front brakes for $995 (the same ones than the cobra R


"
ORIGINAL EQUIPMENT ON THE 2000 COBRA "R". INCLUDES BREMBO 4 PISTON CALIPERS, ROTORS, BRAKE LINES AND HARDWARE"
 

Nazaar33

Founding Member
Feb 20, 2002
401
0
0
In my 2000 Supercharged GT - Raleigh, NC
Jun 18, 2004
#3
  • Jun 18, 2004
  • #3
THanks for the reply stallion98gt.

Your right...and if I had the money to spend on it..I would like to. But unfortunately..I don't have that kind of money at this time.
And...my car is a street car..I don't drive it very hard often..or go to the track. I've taken it to the track a total of two times..since I supercharged it awhile back. Any other suggestions on a upgrade..but maybe not as expensive as the cobra R setup? $995 for just the front..is a little steep for me at this time.

stallion98gt said:
since ur GT is supercharged.. I stronlgy advice upgrading the brakes !!!!..ur car is out of specs anyways...since ur pushing way more than a stock GT...I would recommend BREMBO front brakes for $995 (the same ones than the cobra R


"
ORIGINAL EQUIPMENT ON THE 2000 COBRA "R". INCLUDES BREMBO 4 PISTON CALIPERS, ROTORS, BRAKE LINES AND HARDWARE"
Click to expand...
 
9

98GtRioRed

New Member
Dec 7, 2002
87
0
0
Jun 18, 2004
#4
  • Jun 18, 2004
  • #4
I live in Durham, NC. Anyhow I have a supercharged 98 GT and last weekend put the Baer 13" cross drilled and slotted rotors and new PBR twin piston calipers on my front. Also did the Baer 13" cross drilled and slotted rear rotor with the stock caliper re location bracket. Cost for the front was around $700 from Carolina Mustang Performance in Cary.

Just my .02
 

Nazaar33

Founding Member
Feb 20, 2002
401
0
0
In my 2000 Supercharged GT - Raleigh, NC
Jun 18, 2004
#5
  • Jun 18, 2004
  • #5
yeah...I've been to Carolina mustang performance...i actually live right down the road from them. how much did the rear setup cost??

Mike


98GtRioRed said:
I live in Durham, NC. Anyhow I have a supercharged 98 GT and last weekend put the Baer 13" cross drilled and slotted rotors and new PBR twin piston calipers on my front. Also did the Baer 13" cross drilled and slotted rear rotor with the stock caliper re location bracket. Cost for the front was around $700 from Carolina Mustang Performance in Cary.

Just my .02
Click to expand...
 
9

98GtRioRed

New Member
Dec 7, 2002
87
0
0
Jun 18, 2004
#6
  • Jun 18, 2004
  • #6
$250.00 for both 13" cross/slotted rotors and the brackets.
 

Nazaar33

Founding Member
Feb 20, 2002
401
0
0
In my 2000 Supercharged GT - Raleigh, NC
Jun 18, 2004
#7
  • Jun 18, 2004
  • #7
thanks.
mike
 

StangDriver5650

New Member
Mar 5, 2003
115
0
0
Atlanta, Ga
Jun 19, 2004
#8
  • Jun 19, 2004
  • #8
Any website I could get the Baer 13" upgrade from? $700 sounds pretty good for the rotors / calipers.
 

stallion98gt

New Member
May 12, 2003
1,802
0
0
Los Angeles, CA
Jun 19, 2004
#9
  • Jun 19, 2004
  • #9
check that:
http://www.discbrakesrus.com/make/ford/mustanggtff.htm

u can get nice front/rear kit combo for around $900
 
R

Rio96

New Member
Sep 11, 2003
99
0
0
Jun 19, 2004
#10
  • Jun 19, 2004
  • #10
Rotors are generic.
Check out Wilwood.
 
You must log in or register to reply here.

Similar threads

C
Fox Need help identifying brake setup
  • Cypher02xd
  • Apr 25, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
2
Views
148
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Apr 27, 2026
Mustang5L5
Brakes Brake caliper ID help
  • kidott
  • Sep 2, 2025
  • Fox 5.0 Mustang Tech
Replies
1
Views
203
Fox 5.0 Mustang Tech Sep 2, 2025
AeroCoupe
L
05GT brakes on a 98GT?
  • lparsons42
  • Sep 6, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
0
Views
175
1996 - 2004 SN95 Mustang -General/Talk- Sep 6, 2025
lparsons42
L
9
Brakes Rear brakes feel stuck after replacing pads and rotors
  • 99stanggtvinx
  • Aug 31, 2024
  • SN95 4.6L Mustang Tech
Replies
1
Views
528
SN95 4.6L Mustang Tech Sep 1, 2024
nickyb
S
Brake issue after changing pads and rotors
  • squirrel0420
  • Jul 14, 2025
  • 2005 - 2014 S-197 Mustang -General/Talk-
Replies
15
Views
846
2005 - 2014 S-197 Mustang -General/Talk- Jul 18, 2025
nickyb
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?