Just a quick write-up, since I really couldn't find anything on the ole interweb for this.
Remove your stock OEM radio, there are enough vids on the net for this.
- There are four (4) #10 Torx hex screws holding the faceplate, remove them and slide the plate over the retaining clips "carefully"
- Flip the faceplate over and you will five (5) very very small (4/32nd) screws (bright silver) - see pictures - I didn't have a 4/32nd socket, so I used pliers, very carefully, save all the screws -
- switch everything over and then I would suggest 'testing' the radio before putting all the interior trim back.
Remove your stock OEM radio, there are enough vids on the net for this.
- There are four (4) #10 Torx hex screws holding the faceplate, remove them and slide the plate over the retaining clips "carefully"
- Flip the faceplate over and you will five (5) very very small (4/32nd) screws (bright silver) - see pictures - I didn't have a 4/32nd socket, so I used pliers, very carefully, save all the screws -
- switch everything over and then I would suggest 'testing' the radio before putting all the interior trim back.
Last edited: