• Mustang Forums
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • Classic Mustang Specific Tech

351c MSD wiring help

  • Thread starter Thread starter 73nancy
  • Start date Start date Nov 16, 2007
7

73nancy

New Member
Sep 9, 2007
27
0
0
Nov 16, 2007
#1
  • Nov 16, 2007
  • #1
well im in a bit of a situation with my 73mach got the motor in and ready to fire in the car. but im having trouble wiring her up again. puting msd in with a 6al box with blaster 2 coil with msd dist. problem im having is taping into the old harness and geting the car to turn over. got most everything wired up but i still got nothin. do i need a ballest resitor hooked up with MSD? i got the msd hooked in right where she needs to be and fuel pump is working but wont crank.
ps any pics of your engine bay with wiring hooked up will help. got a bad harnes with duraspark so its F-up.
 
G

Gud T.B. Blown

Member
Dec 9, 2004
583
1
18
Nov 16, 2007
#2
  • Nov 16, 2007
  • #2
I hope these pics help. I can't help with tech questions because I didn't install this and the car is in the paint shop right now so I can't get any more pics.





 

Attachments

  • Picture011.webp
    72 KB · Views: 158
  • Picture006.webp
    43.9 KB · Views: 134
  • Picture007.webp
    43.6 KB · Views: 144
  • Picture009.webp
    40.6 KB · Views: 160
  • Picture008.webp
    60.8 KB · Views: 159

65fastbackresto

Active Member
Apr 13, 2007
1,229
7
39
AR
Nov 16, 2007
#3
  • Nov 16, 2007
  • #3
What would the MSD have to do with it cranking?

It just gives it fire, has nothing to do with whether or not it`ll turn over. At least in my case it didnt, can you post pics of battery to starter connections maybe?

And if you have a firewall mounted solanoid, have you tried "jumping" across it to try and kick it over?
 
7

73nancy

New Member
Sep 9, 2007
27
0
0
Nov 16, 2007
#4
  • Nov 16, 2007
  • #4
ya i went back out today to try and figure it out. i was looking at engine pics from before but not much luck. i got the fuel pump working and a + wire from the key and hooked that one to the msd box like i needed. then tryed it and all of a suden i got no power to that wire now. im hoping i didnt blow up my msd box. is there a simple way of hooking it up to juts run cause all i want to do is start the motor. i got the msd hooked up right but no crank.. my main problem i think is the starter solanoid. it has power on the batter side but cant get power to the other side of it. what kind of wires do i need on the little posts non that i have on right now got and juice. im so lost ill try to post pics my harness is junk its hard to find what goes where. went to cross the starter solanoid and sparked alot my dad did it before the key was on. right no i have no baalst rest. so is that it?
 

HookandLadder

Founding Member
Feb 17, 2001
261
0
17
St Louis
Nov 17, 2007
#5
  • Nov 17, 2007
  • #5
Try looking up your set up on the MSD site and going through the connections to verify they are right.

http://www.msdignition.com/1download.htm
 

dodgestang

Active Member
Dec 15, 2003
1,360
0
37
Cecil County, MD
Nov 17, 2007
#6
  • Nov 17, 2007
  • #6
When you turn the key...if the motor doesn't crank...it has nothing to do with the MSD.

Check to make sure the selonoid is working.
 
7

73nancy

New Member
Sep 9, 2007
27
0
0
Nov 18, 2007
#7
  • Nov 18, 2007
  • #7
ok been trying to figure my mess out and on the starter sol. the two small post do they need power from the key? i have no juice to either right now bad ground? also does the block ground by the firewall need to be hooked up? thanxs a bunch guys
 
7

73nancy

New Member
Sep 9, 2007
27
0
0
Nov 18, 2007
#8
  • Nov 18, 2007
  • #8
got it running thanxs for the help guys.i might need a new screw driver time im done. crossing the starter sol. kinda welded it a bunch of times but motor sounded realy healthy but couldnt run for long cause no coolant so didnt want to over heat it so got it started just enough to wear off the pre winter sit period.
 
You must log in or register to reply here.

Similar threads

P
Electrical MSD box wiring for an 88 GT- few questions.
  • pindude80
  • Jul 20, 2024
  • Fox 5.0 Mustang Tech
Replies
3
Views
954
Fox 5.0 Mustang Tech Jul 25, 2024
pindude80
P
0
V6 to V8 Swap info
  • 02_2v_Curtis
  • Jan 11, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
0
Views
765
1996 - 2004 SN95 Mustang -General/Talk- Jan 11, 2026
02_2v_Curtis
0
Electrical Need some help with my wire tuck
  • AnthonyA1234
  • Oct 29, 2023
  • Fox 5.0 Mustang Tech
Replies
8
Views
2K
Fox 5.0 Mustang Tech Oct 30, 2023
General karthief
9
1995 Mustang GT Crank no Start
  • 95gtV
  • Sep 1, 2023
  • 1994 - 1995 Specific Tech
Replies
6
Views
3K
1994 - 1995 Specific Tech Dec 4, 2023
SRago
S
D
Electrical 89 fox 5.0 crank no start when cold
  • DruryFoxbody
  • Aug 23, 2022
  • Fox 5.0 Mustang Tech
Replies
14
Views
3K
Fox 5.0 Mustang Tech Aug 27, 2022
jrichker
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • Classic Mustang Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?