351w based stroker info needed?

[POWER302]

To make the 392 stroker It says you need.

Factory 351w Block
The 3.85" stroker crank
Factory 351w rods
Factory Compresion height 0.030 302 pistions
And that will get you 392ci

My questions

Can I just hone the block and use stock Forged 5.0 HO pistons and end up with a 387 or so ci stroker?

What Compresion should you get with that setup and "Lets say" a 65cc Combustion chamber head?

 

[vristang]

Assuming the bores are good, you probably could just hone the 351w block.

Not a clue on compression...
Google should return some good free calculators for CR though...


jason

 

[Vipersix]

The 3.85" stroke coupled with the stock 4.00" bore will net you a 387 ci motor. The compression is based on too many variables to say with any certainty. I'd say you're looking at around 11:1.