just wondering if anyone has done this? basically i'm tired of looking for a good clean rolling chassis so i'll go a different route....i already have a motor built etc....what would it take to put a 351 in a 94 and up 6cyl car? i can find all kinds of super clean 6cyl cars but i don't wanna butcher the wiring...the motor is carbed...ignition is all standalone msd stuff...i still want to keep turn signals etc....is it just a matter of a k-member swap? if so bye bye fox body!!!!
351w in a 94 and newer stang?
- Thread starter lgil351
- Start date
lgil351 said:
I dont think you have to swap the kmember. For a 6 cyl car it should be the same as a v8 car. You will have the same issues with oilpan, exhaust and some brackets. You will also need a raised hood. Might want to post this in the 94-95 forum to get a better answer than "I think."
Similar threads
