I tried to remove my driveshaft yesterday with the engine out and have had no luck. I have tried a breaker bar with the wheels on the ground, chocked, etc. and they still spin a little. I have tried with the car in the air, 90-100 psi impact with an elbow (I know, I know) to be able to reach the 12 point 12mm and no luck....I know this should be a ten minute job, I have done these pleny of times before but every other time the engine was in the car still and I was able to put the car in gear to be able to provide resistance. Any tools or attachments/special elbows that anyone would suggest to get me a better angle at this thing? Or for that matter if you have removed the d/s an easier way with the engine out I am all ears. Thanks,