I purchased the #995 addco 3/4" rear sway bar for my 68 stang. I am pretty sure that the sway bar must be installed behind the rear axle with the arms pointing forward. But I run into some issues.
The bar is slightly too narrow, so that the bushings and u-brackets won't match with the frames.
The bar also collides with my dual exhaust pipes.
And since the arms point forward and go over the rear axle, I cannot use the 1" lowering blocks between the leaf springs and the rear axle, beacuse the bar will collide with the axle. This is because the bar ends are connected to the leaf springs.
Does anyone have this bar installed? I'd appreciate some pictures of the installation and tips on how to overcome the issues i face.
The bar is slightly too narrow, so that the bushings and u-brackets won't match with the frames.
The bar also collides with my dual exhaust pipes.
And since the arms point forward and go over the rear axle, I cannot use the 1" lowering blocks between the leaf springs and the rear axle, beacuse the bar will collide with the axle. This is because the bar ends are connected to the leaf springs.
Does anyone have this bar installed? I'd appreciate some pictures of the installation and tips on how to overcome the issues i face.