86 5.0 Wiring Help? (Coil)

Currently - I'm doing a 68 Shelby Convertible tribute.
Have a 5.0 EFI (speed density) motor from an 86 Fox mounted, ready to go.

Problem - A guy gave me a modified wiringness ( based on painless supposedly) that he integrated into a single main harness. Well, the FPR doesn't work and injectors wont open. He says the 3 computers I have are bad. Hard to believe

So I now have my original 86 main harness back. There is no coil wiring on this harness? I beleive the coil wiring was a part of the another harness I don't have. I"m trying to figure out how to run separate wiring (if possible) or splice in the coil lines into this original harness. I do have the fuseable link wiring in both harnesses so I thought I could cut the coil wires from the bad harness and splice them into the original. However I cannot find the other wire (ground? - the hot line is green w red stripe) in the original wiring harness? Can I just ground it somewhere? I figure not. I'm at a loss how to proceed. I

Thanks for any input.


Hisser

Hey jrichker,

Man, what a resource!! Thanks for the tip. This should fix me up quick. By the way, I'm in Rome, GA. Appreciate your hospitality and assitance my GA friend.

Hope to get this machine rolling sometime soon.

Hisser