• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

88gt Terrible idle and real rich

  • Thread starter Thread starter hotrodford67
  • Start date Start date Jul 21, 2005
H

hotrodford67

New Member
Jul 21, 2005
3
0
0
Jul 21, 2005
#1
  • Jul 21, 2005
  • #1
I changed my speedometer cable yesterday on my 88 gt , all appeared to go well but when i fired up the car afterwards it was running terrible. Appears to be real rich as there is lots of black smoke. I checked to see if i had dislodged any wiring in the process of the speedocable change but cannot find anything wrong.
Anyone have any ideas, what could I have disturbed that would cause this ?.
 

BlackGT89

Member
Dec 16, 2002
774
8
18
Huntsville, AL
Jul 21, 2005
#2
  • Jul 21, 2005
  • #2
Not that it's related to your speedo cable, but pull the vacuum line going to your fuel pressure regulator and see if there is gas in the vacuum line. If so, you need a new fuel pressure regulator.
 

DW5.0L

Member
May 28, 2005
172
0
16
Florida
Jul 21, 2005
#3
  • Jul 21, 2005
  • #3
Man that is a strange set of symptoms related to a speedo cable swap. Especially if the car ran great before touching it. Make sure all plug and cap wires are snug.
Check the timing and or compression. If all checks out good, pour some SEAFOAM in that pony and decarbon the engine and clean the injectors. Good luck solving it.
 
H

hotrodford67

New Member
Jul 21, 2005
3
0
0
Jul 21, 2005
#4
  • Jul 21, 2005
  • #4
Thanks for the answers so far, I'll check the fuel press reg, and go from there , car ran fine before I got my mitts up in the dash and rooted around cant help but think I caused it but it may well be a coincidence.
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Jul 21, 2005
#5
  • Jul 21, 2005
  • #5
Did you knock the vacuum line off the MAP sensor when you routed the new speedo cable down the firewall?
 
H

hotrodford67

New Member
Jul 21, 2005
3
0
0
Jul 21, 2005
#6
  • Jul 21, 2005
  • #6
Thanks all for your input.
Fixed - vacuum line under rear of upper intake to sensor on firewall , i guess i knocked it off and couldnt see it in the evening light as it had made its way well out of plain sight. - A couple more of these vacuum / sensor events and I'll be ready old school this puppy with an torker intake and a 650 holley.
larry
 
You must log in or register to reply here.

Similar threads

K
2003 GT High Idle, vac leak process
  • krysber
  • May 11, 2025
  • SN95 4.6L Mustang Tech
Replies
2
Views
473
SN95 4.6L Mustang Tech May 11, 2025
krysber
K
S
Engine I am having trouble with the engine in my 1991 Mustang.
  • sands9330014
  • Sep 28, 2024
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
47
Views
2K
Fox 5.0 Mustang Tech Apr 12, 2025
Mindseye007
C
Engine Code 13 and high idle
  • CmdrDerp
  • Dec 14, 2024
  • Fox 5.0 Mustang Tech
Replies
17
Views
929
Fox 5.0 Mustang Tech Dec 21, 2024
manicmechanic007
J
Engine No power after idle
  • JustinTilley86
  • Aug 10, 2024
  • Fox 5.0 Mustang Tech
  • 2
Replies
34
Views
2K
Fox 5.0 Mustang Tech Sep 23, 2024
General karthief
B
94 cobra possible idle issue?
  • Bowen94
  • Feb 15, 2024
  • 1994 - 1995 Specific Tech
Replies
11
Views
2K
1994 - 1995 Specific Tech Feb 16, 2024
Noobz347
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?