90mm TB and 95mm MAF too big??

[caseywan]

I'm in the process of building a new motor for spring. It is a Dart based 331, all forged internals, wicked ported Twisted Wedge heads (3000lb car N/A 345cu went 9.3 with these heads), ported/welded GT40 lower, Kenne Bell 2.2 with Flowzilla manifold to accept 90mm TB, and full Bassani 3" exhaust w/ LT's.

I already bought a 90mm Acufab throttle body, and am looking at getting a C&L 95mm MAF. Will these be too big for my combo?

 

[795.0pacecar]

If you weren't supercharging it, I would say that both are too big, but since you are, you'll be fine.

 

[5spd GT]

Yep, I agree.

 

[304billet]

How much power r u planning on putting down?

I run a Accufab 75mm race TB and 85mm C & L MAF on a NA 331 that will put down 450 when it is blown.

Custom chip burned to dial in A/F right now.

 

[Grn92LX]

90mm is PERFECT! As long as the inlet is matched to 90mm your fine.

 

[caseywan]

Ok, cool. I plan on making at least 500rwhp.