91 GT info/help

ajp91gt

New Member
Sep 26, 2007
9
0
0
Hi all!
im a first time FI 5.0 mustang owner. so far i love it! heres my question(s)
1.i remember years ago there was a thing called the 2 hr tune up...or something to that nature. does anyone know what i mean?it was basiclly a bunch of fre/low cost mods o boost performance. next if im wrong in this, where is a good place to start. this car is stock..77000 mi car, untouched.

2. the dash lighs dont work, aside from the obvious,fuse,where else do i go. all of the other lights work, includeing the dome light and idiot lights, just not the dash lights.

any help on this stuff would be great. thanks alot
 
welcome! glad you're enjoying the car! there's a VERY knowledgable guy on here named jrichker who has a free hp list he'll probably post here for you. other than that, best place to start is a set of gears and full exhaust. is your car an aod or 5 speed? how much are you looking to spend? as far as the dash lights, check the dimmer switch. if that goes, none of your dash lights will work. good luck!
 
well, i want to try to just spend a minimal amount of cash right now on the HP. i want to work the bugs out of the car and focus on the body. id like to stay around the 1000.00 range in hop ups. thanks
 
A solid tune-up is where I'd start (unless you know it's had one recently). Plugs, wires, cap, rotor, fluids changed, check brakes and suspension stuff, etc.

As far as cheapo/free mods, bumping the timing is commonly done. Some like to remove the airbox silencer.

I agree about checking the dimmer. Fuse 13 is for the gauge lights (a 5 amp fuse IIRC).

Good luck.
 
Set the ignition timing at 12-14 degrees BTDC. You may find that you need to run Premium gasoline.

On a budget? do the junkyard upgrade...

Gears - 87-88 T-Bird Turbo Coupe rear axle - disc brakes and 3.55 or 3.73 gears in one package for $125-$300. Add another $100-$200 or so to complete the brake upgrade.

94-95 Mustang GT MAF - $40-$100. It is 70 MM instead of the stock 55 MM on regular stangs built prior to 94. It uses a slip on duct on the side that goes to the throttle body and a 4 bolt flange on the other. You need a flange adapter to fit the stock slip on air ducting that goes to the air box. Wiring plugs right in with no changes. *1 *2

95-97 Ford Explorer intake manifold & throttle body $150-$300. The intake manifold flows 220 CFM +, much better than stock. Throttle body is 65 MM, bigger than the 60 MM on stock stangs. I got a 96 with EGR passages that match the stock setup, so my smog gear works just like factory. You’ll need a 65 MM EGR spacer & new gaskets for $65-$90 so you have a place to mount the EGR & throttle linkage.

3G alternator from 94-95 Mustangs or other Ford. $20-$120. A must have to make the electrical system work like it should or if you have an electric fan. You’ll need a 4 gauge power wire and a 125-135 amp fuse to go with it about $15- $30.

Lincoln MK VIII electric fan -$40-$160. Free up some HP by not having to drive the stock fan. The 3G alternator upgrade is a must have prerequisite before you do the MK VIII fan. You won’t have enough electrical power if you don’t do the 3G upgrade.

Aluminum driveshaft: (courtesy of shawn13) It needs to be from a 92-93-94 Aerostar AWD and you will need the u-joint, part #353 from NAPA. It should bolt right up after the u-joint swap.

*1.) Metal flange adapter http://www.kustomz.com/cat3.html Buy the TR70 for $44.95. Or spend some time on eBay looking for one that may fit.

*2.) MAF & sensor interchange
The 94-95 Mustang 5.0 MAF & sensor is also found on:
1995-94 Mustang 3.8L F2VF-12B579-A2A,
1994-92 Crown Victoria 4.6L F2VF-12B579-A2A,
1995-94 Mustang, Mustang Cobra 5.0L F2VF-12B579-A2A,
1994-92 Town Car 4.6L F2VF-12B579-A2A,
1994-92 Grand Marquis 4.6L F2VF-12B579-A2A,
Evidently the –A1A, -A2A, AA, etc. on the end of the part number is a minor variant that did not change the operating specs. You should be able to ignore it and have everything work good.