93' Cobra intake on a 94' GT?? Am I F@#$&*?

[LandonC]

Hey guys! Just wanted to say WOW first! I should've been registered a long time ago! O.K. to the problem at hand. I just bought a 93' style cobra intake and 76mm C&L maf meter off my good buddy. I don't know if it will fit on my 94' GT? FRPP, Edelbrock, Trick Flow, and Professional Products all make the elbows for 94-95 intakes. Does anybody know if they're application specific or if I can use them on the 93' intake and get away with it? What if I "modified" a cold air intake, and if so, which one? The one for the 93' and earlier, or the one for my car? I've searched all over the net for any information reguarding the install, but as you can imagine, no luck! I guess thats why there's STANGNET.COM huh? I'm looking for someone who has expert knowledge on it, but I don't give a crap right now! Any educated guess will work for me!!!! Ya'll know how it is! Thanks everybody!

O.h. Leave a thread, or e-mail me if you can. (I don't have much time on the net) And if I find out this isn't going to work, does any one want a 93' Cobra intake for about $200.00? Comes with a 70mm throttle body, and has holes(buddy had nos, but plugged for now) drilled for NOS!!!

[email protected]

 

[jermy82]

Yeah, I'm pretty positive the intake will work on a 94/95 just fine. It might just rub the hood a little bit like the other intakes. I don't see why the elbow adapter wouldn't work either. You'd probably have to get a different throttle body for it unless you rigged the angle somehow....I'm not sure if the C&L would work... I know you can change the calibration for injector size on those, but it might need to be sprcifically for a 94/95. Anyways, good luck and hope this educated guess helps.

 

[urban96]

you could convert your car to work with the fox TB, i think it was RIO that recently did this, i dont know what parts are needed to do it tho

 

[stang_gt_1994]

I also have a FOX setup. Pretty easy and looks really clean.

 

[RIO5.0]

dig thru this post..it will help you out....i ran an explorer for awhile, then swapped over to the 93...it can be done with the adapter elbow...same info applies to the 93 intake.
im going fox tb style at the moment.
the 93 clears my stock hood with the blanket intact. your EGR stuff is gonna have to be removed to run it.

http://forums.stangnet.com/showthread.php?t=390165&highlight=explorer

 

[LandonC]

re: 93' intake

So....I can use it! sweet! I was getting a little worried. the intake has a Fox style TB, and I was planning on getting rid of the egr crap anyways. Does anyone know if it will clear the strut tower brace, or will I have to remove it?
Thanks guys!

 

[wytstang]

You will have to remove your stock one and get a fms, mac, and or bbk make the one you will need to clear the intake and they go for around 135 or something like that check out www.mustangunlimited.com