95 GT Duckbill fitting sizes

[tmacie]

Hey All,
I'm looking for the sizes of the duckbill fitting that comes off the fuel filter and the one that goes onto the return at the pump. This is for a 95 GT if it makes a difference. I've looked around and am getting some conflicting info.

Thanks,
Travis

 

[toyman]

Hey All,
I'm looking for the sizes of the duckbill fitting that comes off the fuel filter and the one that goes onto the return at the pump. This is for a 95 GT if it makes a difference. I've looked around and am getting some conflicting info.

Thanks,
Travis

My copy of the service manual shows that only 2 sizes (1/4" and 1/2") duck bill clips are used. The needed size for the application should be evident upon inspection.

 

[Last5.0]

Don't know about back at the filter and pump, but the sizes of the duckbill fittings used to connect the soft lines to the hard lines in the engine bay are 1/4" for return and 5/16" for feed.

 

[tmacie]

Toyman, thats the 3rd set of numbers I've seen now. LOL.

Last 5.0, These are the most common sizes I've seen.

Maybe I'll just pickup a variety of sizes and see what works.

Thanks,
Travis

 

[toyman]

Toyman, thats the 3rd set of numbers I've seen now. LOL.

Last 5.0, These are the most common sizes I've seen.

Maybe I'll just pickup a variety of sizes and see what works.

Thanks,
Travis

That's interesting. Here's the two part numbers shown

N802710-S190 Duck Bill Clip (1) 1/4 Inch

N802441-S Duck Bill Clip (1) 1/2 Inch

 

[tmacie]

What manual has those for the part numbers?

I finally got the tank out of the car. The sizes according to my digital calipers are:

Pump outlet 3/8"
Return at pump 1/4"
Fuel filter 5/16" on both ends

Thanks for everyones help.
Travis