• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

A/C pulley problem

  • Thread starter Thread starter bigc2330
  • Start date Start date Jul 24, 2010

bigc2330

Member
Nov 13, 2009
78
7
9
Jul 24, 2010
#1
  • Jul 24, 2010
  • #1
So last Sunday my A/C started blowing hot air while i was driving. So I pulled over and I had smoke coming from the A/c clutch/pulley area. The pulley now makes a grinding noise rather the a/c is off or on. I left the a/c off all week and checked the system out yesterday. I put the a/c on low and it does get cool again, the clutch cycles on and off. So is their a bearing inside the clutch/pulley? If so, should I go that route in buying a new clutch assembly or go with a whole new compressor?
 

trombonedemon

Well-Known Member
Jun 25, 2009
1,962
39
59
U.S.A, U.S.A., U.S.A.!
Jul 24, 2010
#2
  • Jul 24, 2010
  • #2
bigc2330 said:
So last Sunday my A/C started blowing hot air while i was driving. So I pulled over and I had smoke coming from the A/c clutch/pulley area. The pulley now makes a grinding noise rather the a/c is off or on. I left the a/c off all week and checked the system out yesterday. I put the a/c on low and it does get cool again, the clutch cycles on and off. So is their a bearing inside the clutch/pulley? If so, should I go that route in buying a new clutch assembly or go with a whole new compressor?
Click to expand...

Yep, there are bearings. The cheaper route would changing clutch but, I don't know if that would solve your bearing problem. Compressors are not that expensive comparing to the rest of your engine.
I say if you can swing the coins, go and get a new compressor so that you don't have worry about anything else that could go wrong w/the compressor and you have a warranty to have your back.
The only additional cost would be find someone to cycle and recycle the R-134a out of your A/C. The rest you could do your self.
 

COramprat

...I can take it. I think.
20+ Year Stangneter
Mar 2, 2003
8,474
1,463
223
Sea of Tranquility
Jul 25, 2010
#3
  • Jul 25, 2010
  • #3
The clutch assembly is about 150 bucks. That will probably take care of your problem. Look for the link in the "Important Tech" thread at the top of this section for a write up on how to change it.
 

bigc2330

Member
Nov 13, 2009
78
7
9
Jul 25, 2010
#4
  • Jul 25, 2010
  • #4
Thanks guys!
 
You must log in or register to reply here.

Similar threads

P
2002 T5 transmission vibration issue
  • puffoo
  • Feb 22, 2026
  • SN95 V6 Mustang Tech
Replies
0
Views
141
SN95 V6 Mustang Tech Feb 22, 2026
puffoo
P
Engine A/C QUESTION
  • Mindseye007
  • Jun 5, 2025
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
51
Views
2K
Fox 5.0 Mustang Tech May 31, 2026
Mindseye007
T
A/C Compressor Reliability with Supercharger Setup – Need Advice
  • ThotTrap
  • Aug 29, 2025
  • 2015 - 2023 (S550) Mustang -General/Talk
Replies
1
Views
147
2015 - 2023 (S550) Mustang -General/Talk Aug 29, 2025
Noobz347
S
Car shakes when taking off help???
  • STANKYstangs
  • May 10, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
12
Views
175
1996 - 2004 SN95 Mustang -General/Talk- May 27, 2026
LILCBRA
L
Car has been overheating. Not sure what is causing it. Any help would be appreciated.
  • Luckysgirl
  • Tuesday at 4:12 AM
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
2
Views
33
1996 - 2004 SN95 Mustang -General/Talk- Tuesday at 12:58 PM
Luckysgirl
L
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?