ABS sensor switch on non-abs readend...

tomustang

Psychotic Member

Founding Member

Jun 8, 2000

3,434

2

78

McLean Hospital

Jul 3, 2005

#1

• Jul 3, 2005

• #1

I have my GT rearend sitting by collecting dust, the only problem is that my GT was not ABS. Now my question is can you remove the sensors (Cobra) off the axle shafts and place them on the (GT) other shafts? I want to use my GT rearend for now because it was completely rebuilt and has FRPP 3.73's.

 

Mustang5L5

That is…until I whipped out my Bissell

Mod Dude

Feb 18, 2001

43,167

17,862

224

Massachusetts

Jul 3, 2005

#2

• Jul 3, 2005

• #2

Are you talking about the rings that are pressed onto the axles??

The axles are the same for the GT and Cobra, just swap the axles.

I'm not quite sure what you are asking though

 

tomustang

Psychotic Member

Founding Member

Jun 8, 2000

3,434

2

78

McLean Hospital

Jul 3, 2005

#3

• Jul 3, 2005

• #3

Theres an ABS magnetic sensor on the axle. But anyway I was just thinking it would be easier to swap the axles out.

 

Mustang5L5

That is…until I whipped out my Bissell

Mod Dude

Feb 18, 2001

43,167

17,862

224

Massachusetts

Jul 3, 2005

#4

• Jul 3, 2005

• #4

Just swap the axles and brake hardware over to the GT rear end.

 

S

showstopper2

Founding Member

Apr 16, 2001

425

0

0

New Bedford, Ma.

Jul 4, 2005

#5

• Jul 4, 2005

• #5

are you talking about the exciter rings on the axles?