Interior and Upholstery AC Clutch removal and install questions

pats91 said:

First thing you need to do is clean the inside of clutch hub really well. There are internal threads there, but yours are full of dirt. I think the puller you need to use is one the four on the bottom right of the toolkit. Just screw the outer part of the puller into the hub, and tighten the inner bolt until the hub is pressed off the shaft.

Click to expand...

Mustang5L5 said:

It’s one of the four tools on the bottom right of your pic.

you need to use a wire brush and compressed air to clean out these threads



what you do then is unscrew the center of the tool to back the rod out of the tool far enough to thread the tool onto those outer threads.



with the tool screwed onto the outer threads, you turn the center part of the tool in to contact the center threaded rod to push the hub off.

keep tightening and the hub will slip off

Don’t lose the spacer that comes off behind it. That peice is important for setting proper clutch gap

Click to expand...