Aftermarket Mass Air & Sensors

you should be fine on the 30lb injectors. I'm running 30lb on my 331. As for the mass air I had a C&L once then I sold it and got a real mass air meter.

Anderson Ford Motorsport Home Page

Check these guys out. I got my most recent mass air from them and I couldn't be happier.

I ended up getting the Professional Mass Air Systems Velocity Mass Air.

My personal opinion I wouldn't go lower than 30's on a 347, most people even go higher to allow room to grow in the future. You could probably get away with jacking the fuel pressure up a little higher to get more out of the injectors with 24's and still make power but your your not suposed to go more than a 80% full load on the injectors usually. As far as meters go I don't even know whats out there anymore, pro-m used to be the best but I don't think they exist anymore, c&l always had a hit or miss reputation. I think the newest flavor of the month is the abaco programmable meters but get ready to spend some money, and they are huger.

Remember the further you get away from a stock setup more in tuning the car will need, especially in with fuel injectors and maf sensor. Stock computer is programmed for 19lbers and is built around them (upper lower injector slopes, injector break points, injector offset vs battery voltage, and the maf transfer function). you might need to consider some tuning aspects to the car to run optimal.

(imho)

30s should be fine.

If you go bigger than 36's some people start to run into idle quality issues...
(not all, but some)

Whatever meter/inj/etc you wind up with I would budget another 5-600 to spend a day with a QUALITY tuner, at a local dyno facility and get them to burn you a custom tune.

The money will pay for itself a hundred times over in drivability, idle quality, cold startup, etc, etc, etc...

Dave