• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-

Aftermarket Radio Grounding Locations

  • Thread starter Thread starter BigSlappy
  • Start date Start date Apr 27, 2023

BigSlappy

Member
Sep 4, 2022
73
14
18
Buffalo, New York
Apr 27, 2023
#1
  • Apr 27, 2023
  • #1
First thing I want to say is thanks everyone for the amazing help on these foxbodies. My dad has always had a foxbody when I was growing up, so i always grew used to them. Everyone has been super helpful with info and resources.

One of the last issues I really have with this car is the aftermarket radio I installed. When the car is started, you get that alternator whine. I assumed the default ground the default radio has isnt that good, so I just grounded it to the latch nut for the glove compartment. The whine is a lot quieter, but is still there. For anyone who has installed aftermarket radios, how did u guys wire up the power and ground? I have new speakers and amp all connected to each other, so I no its not any old hardware.
 

AeroCoupe

lube between the nut and the face. I know my lubes
Founding Member
Oct 28, 2001
5,914
4,036
183
Claremore, OK
Apr 28, 2023
#2
  • Apr 28, 2023
  • #2
Remove the ground and see what happens. Used to get a ground loop due to the antenna. If that fixed it we left it with the head unit utilizing the antenna for the ground as we were not going to chase the grounding issue with the customer’s car.

That being said if that fixes it check your grounds in the car starting with the battery to body, body to engine block, and the firewall to cylinder head ground strap. If those check out then my guess would be it’s a dash harness ground issue.
 
Reactions: 4cylredfox89

Noobz347

Stangnet Facilities Maint Tech... Er... Janitor
Admin Dude
Jan 4, 1985
43,134
21,305
234
Box behind Walmart
Apr 28, 2023
#3
  • Apr 28, 2023
  • #3
And refrain from adding more than what AeroCoupe listed until you resolve the issue at the very least. [Extra] grounds are what causes a loop and those can induce noise to the head unit.
 
Reactions: AeroCoupe

TIGGER

Founding Member
Mar 6, 2000
877
244
104
Portland, OR
Apr 28, 2023
#4
  • Apr 28, 2023
  • #4
One more thing to add is do not rule out the radio and or amp. I had an annoying whine in my wife's 96 vert a few years back. I chased the grounds. Switched the RCA cable etc.... It ended up being the amplifier that was bad. One of the channels was bad and was picking up the alternator. I figured it out by unplugging one of the channels from the amplifer and the noise went away. Other channel sounded just fine. I replaced the amp and have had no whining issues since.
 
Reactions: 4cylredfox89, BigSlappy, General karthief and 1 other person

limp

wrap a little cheese around it and its a done
5 Year Member
Oct 4, 2020
5,467
2,902
173
Florida
Apr 29, 2023
#5
  • Apr 29, 2023
  • #5
Back in the day, it was the spark plug wires that created all of the noise in our 4 track and 8 track tape decks........
Corvettes needed the stock metal dist cover in addition to as I assume the fiberglass body didn't help....
 
Last edited: Apr 29, 2023

BigSlappy

Member
Sep 4, 2022
73
14
18
Buffalo, New York
Apr 29, 2023
#6
  • Apr 29, 2023
  • #6
AeroCoupe said:
Remove the ground and see what happens. Used to get a ground loop due to the antenna. If that fixed it we left it with the head unit utilizing the antenna for the ground as we were not going to chase the grounding issue with the customer’s car.

That being said if that fixes it check your grounds in the car starting with the battery to body, body to engine block, and the firewall to cylinder head ground strap. If those check out then my guess would be it’s a dash harness ground issue.
Click to expand...
I have my antenna off, so maybe putting it back on will fix it . Ill do that and adjust my brake booster today and update everyone
 

BigSlappy

Member
Sep 4, 2022
73
14
18
Buffalo, New York
Apr 29, 2023
#7
  • Apr 29, 2023
  • #7
TIGGER said:
One more thing to add is do not rule out the radio and or amp. I had an annoying whine in my wife's 96 vert a few years back. I chased the grounds. Switched the RCA cable etc.... It ended up being the amplifier that was bad. One of the channels was bad and was picking up the alternator. I figured it out by unplugging one of the channels from the amplifer and the noise went away. Other channel sounded just fine. I replaced the amp and have had no whining issues since.
Click to expand...
I have a couple amps lying around i can switch out. I really hope its not an amp because thats the only 4 channel one i have
 

AeroCoupe

lube between the nut and the face. I know my lubes
Founding Member
Oct 28, 2001
5,914
4,036
183
Claremore, OK
Apr 29, 2023
#8
  • Apr 29, 2023
  • #8
I missed the amp part. What brand of amplifier is it and where do you have it mounted?
 
You must log in or register to reply here.

Similar threads

D
Engine Coolant and Radio Issues
  • Don7Up
  • Sep 14, 2025
  • Fox 5.0 Mustang Tech
Replies
17
Views
653
Fox 5.0 Mustang Tech Oct 4, 2025
Don7Up
D
E
2007 GT Stalls when lights or a/c turned on
  • ejscarfo
  • Jun 22, 2026
  • 2005 - 2009 Specific Tech
Replies
2
Views
140
2005 - 2009 Specific Tech Jun 29, 2026
ejscarfo
E
A
Resolved 03 GT Parasitic Draw Fuse 26 (PCM)
  • Antrix
  • Mar 22, 2025
  • SN95 4.6L Mustang Tech
Replies
2
Views
737
SN95 4.6L Mustang Tech Mar 24, 2025
89ripper
New radio, but no sound
  • BigSlappy
  • Jan 26, 2023
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
5
Views
2K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jan 27, 2023
AeroCoupe
3
94 Gt to 84 Fox
  • 351C-84'Fox
  • May 16, 2024
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
8
Views
1K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- May 17, 2024
351C-84'Fox
3
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?