Alternator issues

Anyone know where to get a smaller alternator? The new valve covers I put on were supposed to fit, but they didnt. I dont care how many amps as long as it will fit the bracket and not hit the valve covers. Or do any of you guys know how to make the alternator smaller by cutting or grinding.:bang: :bang: :bang:
 
A 6G might work for you. You'd have to measure one and see (maybe hit a parts store and compare it to a 3G).

Good luck.
 
some have used a washer to push out the bracket ever so much to gain the room.

When I put on the fox VC, I had to loosten the bracket alitle and install the VC. Then with the covers on I installed the alt. and then tightend the bracket bolts up. This did 2 things.

1. Got the valve covers on and with them installed the angle of the cover had room for the Alt. The covers would not install with the bracket fully tight or with the alt. installed.

2. The bracket being loose let me install the alt. With both the VC's installed and the alt. installed when I tightend' up the bracket it drew them close and the bracket and alt. cleared as the VC was now down far enough installed.