Another Blower Question

[DoHcHoLlIdAy01]

I have read some threads on here about 03 04 Eaton blowers going on the 99 01 Cobra's. I was wondering if anybody had a complete list of items that would be needed to do this swap. I see many half way (some items) kits available on Ebay for not a lot of money. It seems like if I could find enough good deals on each part it would be cheaper than to spend $5000 on a Kenne-Bell. I know that everyone is going to recommend to just get a aftermarket kit. I am going to make a list going by what I know (might be wrong), if anyone could add on to it, thanks.

1.Blower (of course, but not sure if I need the lower intake though?)
2.Throttle body & Inlet
3.90MM MAF and MAF Sensor
4.255LPH fuel pump
5.42lb. Injectors
6.03 or 04 Cobra ECU
7.Fuel Rails?
8.Intercooler
9.Heat Exchanger

I also heard something about the wiring harness from an 03 or 04, but not too sure? Curious if anybody has even done this swap before on this forum? All feedback is greatly appreciated.

 

[V8MstngPwr]

Not only do I think a KB would be more cost effective... It would simply be a lot more effective overall. They make better instant boost, have a more efficient design, and hold boost all the way through the powerband where our Eaton's lose boost late in the RPM band. Go with the KB, it's just that much better than the Heaton.

 

[sawman70]

You'll also want to skip over the 255 fuel pump and go with the 03 Cobra tank and pumps.