hello i have a 95 5 speed with a new clutch and a low mileage 3.8 that i got direct from the ford warehouse. it has the balancer shaft and all. it is single port though, it was only the shortblock and i put on single port heads and intake. it is setup for a 94-95 car since it has the 95 injectors but if you switch them out to whatever year you have then you can use it too. i messed the lower intake up so it is leaking vacuum there and killing gas mileage. i think i might just take the motor/clutch/t5 out and sell theat for around 650-700 OBO. then i have an 89 notch with in floor subframes,custom interior(not finished,back seat and door panels need to be done),4 inch cowl hood and a set of apc euro tails. i am thinking of taking the motor,trans and rear end out and dropping that in the 95 and putting the 95's rear end back under the 89. i want to sell the 89's rolling chassis with title for around 1100. it is already setup for a carb and a t5 tranny. gas is killing me so once i sell one of those items, my grandma has an old beater subaru wagon that needs a new clutch and could use a reringing and new bearings, that would save me gas out the wazoo. what do yall think, should i go ahead and swap or just try to fix the intake with another and hope that fixes it if it aint an electrical problem or not.