My plan is to run some 15x10's out back on my 67 cpe. the front will be lowered an inch and the back raised an inch. Anyone have pics of how some 15x10's look? I don't want them to stick out and I am afraid without tubing the rear this will happen. Just love the look fo the fat tires sitting out back.
any pics of a 67 cpe with 15x10's out back?
- Thread starter gzminiz
- Start date
-
Sponsors (?)
bdepedro
Member
Here are a couple of shots of my '70 fastback w/ 15x10s on the rear. The wheel well lips were rolled to allow for the tires and the rear springs are stock height. They don't rub at all. Hope this helps.
Taranis
New Member
bdepedro
Member
I don't honestly know, the wheels were on the car when I bought it. I'll see if I can measure it for you.
bdepedro
Member
Taranis said:
I measured the offset of my wheels and there is no offset. I measure 5" from the wheel face to the outer edge and 5" from the face to the inner edge. I'm not using any spacers and again, no rubbing although I've got a '70 not a '67 so I don't know for sure if you will have the same results. Hope this helps!
Taranis
New Member
dodgestang
Active Member
bdepedro
Member
Taranis said:
Bear in mind that my well lips were rolled so I'm assuming that my 15"x10" wheels w/ 295/60s would probably rub otherwise.
Taranis
New Member
bdepedro
Member
I'd definitely use a roller or have a professional do it. Whoever did mine glassed them and did a good job but being glass, one of them has a hairline crack 
. Eventually when I redo the body I'll get new quarters and do them right.
. Eventually when I redo the body I'll get new quarters and do them right.Similar threads
