Got it. Thanks for the additional advice.If you look behind where the dist would be on a Mustang, there's a part number cast into the lower intake.
F87E-9K461-BA is the early EGR style manifold. The 65mm TB can also be modified to work on a FOx
F87E-9K461-BB is the later style non-EGR intake manifold.
If you have the choice, the -BA intake is the one to get. Take the TB and the injectors as well
If you look behind where the dist would be on a Mustang, there's a part number cast into the lower intake.
F87E-9K461-BA is the early EGR style manifold. The 65mm TB can also be modified to work on a FOx
F87E-9K461-BB is the later style non-EGR intake manifold.
If you have the choice, the -BA intake is the one to get. Take the TB and the injectors as well
Really..... Guess I haven't kept up lately. Lol. That's good news.There you go. There is also some company out there that makes a factory looking "5.0 HO" intake plate to fit on an Explorer intake.
Kurt
I wasn't even aware of that. Someone would have to look really carefully, and be very keen to the details to be able to tell that part from a stock intake.That company would be Ford
The stock HO plate fits on fine.
That would be a nice touch. I was going to see if I could somehow modify my old one but getting a replacement sounds like a better plan. THX.There you go. There is also some company out there that makes a factory looking "5.0 HO" intake plate to fit on an Explorer intake.
Kurt
Cut off the heads of two screws and glue them on the blanks.
That company would be Ford
The stock HO plate fits on fine.
I once polished a Cobra intake to a mirror finish. That was back in high school when I had like...lots of extra time.That one wasn’t mine. Just a random intake off the net.
There is actually a whole Mythbusters episode on the practice.I polished a turd once, yeah I'm a genius, @revhead347
That’s exactly what I want to do with the intake I have. Going to go on my Mercury eventually.That one wasn’t mine. Just a random intake off the net.
here’s mine, but I’m actually going to run a 93 cobra intake. This one will be a wall-hanger
I put a little extra work into it to make it look like a stock HO intake. Ground the nub off the side and took off some casting flash to smooth it up a bit like the HO upper.
That's a good look.That company would be Ford
The stock HO plate fits on fine.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?