anyone know about transmissions???

[caship]

I have an Auto tranny and I have the following problems:

Fluid is burnt
Trans shifts to early and skips third
Internal control module run error PO605

Was told it needs internal inspection and possible rebuild.

Ok.... If I need that the guy says that it could be from 300-1000 to fix and he said that was conservative.

Should I let them rebuild it or should I put a new tranny in that is more race specific.... saw an ad in MM&FF for GER for tranny's

What do you guys think

My mods are in my sig.... I have an autologic chip so that may explain the computer error.

 

[FallenPhoenix]

I don't see anything in your sig that should cause that kind of problem but who knows. If you plan on adding a blower or running nitrous I would get a built trans just so you don't have this problem again. I'm not sure what to suggest though since I'm not up to date on Ford auto transmissions. What about a nice TH400?

 

[2002BLGT]

how many miles on it , just to see before you spend the $$ on it , why dont you unhook one of the cooler lines and run a hose in a big bucket , and get about 3 gallons of tranny fluid , start and stop the car for a few seconds while adding new fluid try to keep the fluid level the same as what you add as what pumps out , might have to add or let some pump out when you get done but make sure you run about 3 gallons through it , the hose will pump the old fluid the in bucket , do this first and then unhook the battery for 5 minutes when you get done , and see if the code comes back , then drive it and see if it fixes it , you would be surprised what new fluid can do especially when you flush the whole system like im talking about , if that doesnt help , dont waste $$ on bandaids , get a built tranny for it .