anyone know what size belt for bypassing A/C only?

As part of my runaway winter project I too removed my A/C and need this very thing....awsome man thanks.

by run-away...

pulled the intake to setup the valvetrain, then pulled the brackets off to get a better angle at that, then totaly removed them and got them powdercoated. While I was at it pulled the timing cover and water pump (noticed a little seepage-SP?- from the water pump bolts) and am repainting them to match the brackets now... started cleaning up the upper intake further and getting it powdercoated now too, while I was at it my condenser has a hole in it so I pulled the A/C stuff out...now that all that is out of the way I am going to re-paint the engine bay black, and re-paint my fox valve covers too :OT:

There is a chart in the FAQ section.

My bad... I used a 91.5" when i had my S-Trim. I was using stock size pullies.