Anyone Run 1.6-1.7 Stud Mount RR's and...

want to let me borrow them? I have serious valvetrain noise and i would like to take the RR's out of the equation..if anyone would be willing to let me pull their RR's, put them on my car(at your location) for a few minutes while i listen for noise, then put them back on your car i would really really appreciate it! i'll even throw in some new rubber valve cover gaskets and say 10 bucks?

i get plenty of oil, but on startup if i watch the rockers they randomly fill up with oil, not front to back like you would think...the contact point is spot-on(8.350" trickflow pushrods) and it's a hydraulic flat tappet setup..today i'm going to adjust to zero lash + 1 turn instead of 1/2 turn like i always do, because i never adjust them when the engine is hot, always cold..from what i read it should be dont with the engine fully warmed up

nevermind, mods can delete this thread. I'm 99% sure it's the lifters. most of the noise went away and the noise only happens at 1,800RPM now instead of 1,300-1,500 and is quieter..i need to recheck the drivers side later