Are our foglights 12v? Can I use the power from one as a power source for nitrous?

[BlueOvalStangGT]

I dont have my fog lights anymore due to my Saleen front, so I was thinking of using the wire that powers my fogs, to power my zex nitrous kit. Like that I will already have the switch and everything mounted, and the fog wires are pretty close to where I mounted my zex box. What do you think? I guess I could take my DMM to figure it out but this is easier!

 

[The Green GT]

Do it.

 

[HISSIN50]

Not only that, but if you are tapping in near the fog light connectors (at the front fascia), you will have power fed by a relay (always nice compared to running all the current through a switch alone).



Good luck.

 

[BlueOvalStangGT]

I plan on cutting the plug off my fog light (or seeing if they sell something at advance) so its a direct plug in without cutting the factory harness. I shall post pics when complete.

 

[donjohn]

Just something to think about... If you use that line, wont you have to have your lights on to use the foglight switch, or at least the parking lights? I can't remember if the lights have to be on or not...

 

[Blackened302]

^^not if he did the re-wire using the vert harness

 

[OrangeMustangGt]

just get an add-a fuse from autozone and run a dedicated 10a circuit. It needs to get its feed from the cabin anyhow for the arming switch.....use a switched feed so it wont be left on