1969 CONVERTIBLE OWNERS. I NEED A MEASUREMENT
HI I'm looking for a measurement for chepsk8....I bought new doors because I thought my old doors were bent as the bottom of the doors stuck out about a quarter inch on both sides but just in the back. Every thing up front lined up pretty good. I started shimming out the top hing to bring the bottom rear in and I almost got it there but now I have a huge gap between the fenders and the hood. Any to make a long story even longer I think my rear quarters are bowed out at the top.......This is the measurement I'm looking for......The distance between the top of the rear quarters measured from the hole that the glass comes up through at the front most spot outside of the glass actually where the metal meets the rubber trim piece. If you can help me out call me or email 612- 309- 4356 or [email protected] I could email you a picture of the very spot that I am measureing from .
HI I'm looking for a measurement for chepsk8....I bought new doors because I thought my old doors were bent as the bottom of the doors stuck out about a quarter inch on both sides but just in the back. Every thing up front lined up pretty good. I started shimming out the top hing to bring the bottom rear in and I almost got it there but now I have a huge gap between the fenders and the hood. Any to make a long story even longer I think my rear quarters are bowed out at the top.......This is the measurement I'm looking for......The distance between the top of the rear quarters measured from the hole that the glass comes up through at the front most spot outside of the glass actually where the metal meets the rubber trim piece. If you can help me out call me or email 612- 309- 4356 or [email protected] I could email you a picture of the very spot that I am measureing from .
