ATTN: Zex users

5LiterWes

Member
May 7, 2002
176
15
19
Milwaukee
So my buddy came up with a kit for 50$ sans bottle. Trying to figure out where to mount the control module. My engine is all stock with a stock intake tube and airbox still. I do not see anywhere big enough on the passenger side to mount the Zex control box. Considering a BBK CAI intake to clear up some room on the passenger side fender.

What says you Stangnet?
 
  • Sponsors (?)


He's talking about the management unit box. With a BBK CAI mine fit where the airbox used to be. Other than that, you have very few options due to line length
 
IMG_0243.jpg
 
take off the wipers then take off the cowl vent put the box close to the passaenger side there is a ton of room for it and no one will know its there. Drill a hole almost even to the intake tube and run the line right into it, cover it with some split tubbing and your done, not really but close to it
 
Grommet on the pass. Side behind the glove box. Its for the harness to go through but there's room for a nitrous line. That's how I always did mine