Awesom! My lower intake is cracked! Yay

Stock intake is cheap, $150 I believe, but takes a while to install.

Instead of tightening until it cracked using teflon tape or RTV would have been the way to go...

time for the PI swap and sorry to hear that

I put a Dorman aftermarket (like $200) with the aluminum runner on my car like two days ago and it works great! Well, great for a plastic intake manifold ..

But before you get into all that, assuming you just want to get it to stop leaking until you can figure out what you want to buy, bust out some JB weld. I had a similar issue except I didn't crack my intake. The nut that the sensor is screwed into, blew out of the intake on my car. For two years I had some JB weld on it and that held it in place with no prob. So if you want to repair the crack temporarily, take the sensor out, dry off area, JB weld away. I finally had to replace my intake because it cracked in the thermostat housing area .. anyway, JB weld then decide which intake you want. My 2 penniez.

JB Weld for teh WIN