back spacing for 15" weld draglites for 96

B

blown96gt

New Member

Oct 19, 2008

2

0

0

Oct 19, 2008

#1

• Oct 19, 2008

• #1

I just bought use draglites 15x10 51 offset 7.5 backspace. Are these correct for my 1996 gt. Can i run a 10" slick with stock ride hieght? I have have drag launch springs i bought for the car but haven't put on yet. I think they will lower the car 1.5" will i then have a tire clearence problem? any help would be appricated.

 

Shiroelex

There's nothing worse than aut

Founding Member

Aug 23, 2001

728

1

27

Westland, MI

Oct 19, 2008

#2

• Oct 19, 2008

• #2

That's a lot of backspacing. For a 10" wide rim, I've usually heard of them being more around 5.5 to 6.5" for our cars.

 

B

blown96gt

New Member

Oct 19, 2008

2

0

0

Oct 19, 2008

#3

• Oct 19, 2008

• #3

I guess i will try to mock them up. I hope i can tell with no tires. I don't want to buy tires if they won't work.

 

Shiroelex

There's nothing worse than aut

Founding Member

Aug 23, 2001

728

1

27

Westland, MI

Oct 19, 2008

#4

• Oct 19, 2008

• #4

A mock-up will help. Tape a piece of string to the inner lip of the fender, and have it hang down the front of the rim. I'd assume at least a half an inch wider for the tire, especially for during wrinkle action and when the rear drops on launch. On my 02, 6" was the perfect backspacing for a 10" wide with 26x10 slicks, albeit I really need to roll my fenders. I believe the 94-98 8.8s were a tad bit narrower than the 99-04s, so that backspacing might work out for ya.

 

M

milhous

New Member

Oct 20, 2008

1

0

0

Marshalltown, Iowa

Oct 20, 2008

#5

• Oct 20, 2008

• #5

I would say do the mock-up with the rims.

And unless your drag springs are cut, they should not be any lower than stock.