Engine backfires:
1.) Excessively lean mixture. Look for vacuum leaks, low fuel pressure, dirty injectors or bad injector electrical power, EGR stuck open.
2.) Spark plug wires crossed or cross-firing.
3.) Sticking intake valve, bad valve spring, poorly adjusted valves.
4.) dirty or failed MAF sensor - look for code 66 when you dump the codes.
Use a vacuum gauge to look for sticking valves. The reading will be low (8"-14" @ 1200 RPM) and the needle will sweep every time the cylinder fires.
Use a fuel pressure gauge to tap the fuel pressure test point just behind the alternator. Measure the pressure with the engine idling, vacuum line off the fuel pressure regulator. You should see 38-40 PSI.
Do a cylinder balance test to isolate bad cylinders.
Cylinder balance test:
Warm the car's engine up to normal operating temperature. Use a jumper wire or paper clip to put the computer into test mode. Start the engine and let it go through the normal diagnostic tests, then quickly press the throttle to the floor. The engine RPM should exceed 2500 RPM's for a brief second. The engine RPM's will increase to about 1450-1600 RPM and hold steady. The engine will shut off power to each injector, one at a time. When it has sequenced through all 8 injectors, it will flash 99 for everything OK, or the number of the failing cylinder such as 22 for cylinder #2. Quickly pressing the throttle again up to 2500 RPM’s will cause the test to re-run with smaller qualifying figures. Do it a third time, and if the same cylinder shows up, the cylinder is weak and isn’t putting out power like it should. See the Chilton’s Shop manual for the complete test procedure
Here's the link to dump the computer codes with only a jumper wire or paper clip and the check engine light, or test light or voltmeter. I’ve used it for years, and it works great.
See
http://www.troublecodes.net/Ford/
OR
See
http://www.dalidesign.com/hbook/eectest.html for more descriptive help
OR
See
http://www.mustangworks.com/articles...-iv_codes.html
For those who are intimidated by all the wires & connections, see
http://www.actron.com/product_detail.php?pid=16153 for what a typical hand scanner looks like. Normal retail price is about $30 or so at Walmart.
Or for a nicer scanner see
http://www.midwayautosupply.com/deta...ption.asp?3829 – It has a 3 digit LCD display so that you don’t have to count flashes or beeps.. Cost is $33.